Barco E-2320 C (SE) system manual Select the function Preferred Input Freq

Troubleshooting

Problem description	Possible tests or solutions
On a dual-head system,	• Switch the video cables at the
the images on the left	display controller or at the display
and right display seem to	video inputs
be switched

Note: What if the graphic board resolution is too low

Some non-Barco graphic boards (e.g., single-link boards) may have an insufficiant resolution to drive the display. You can solve this problem by forcing the graphic board to operate on a lower vertical frequency. Therefore, proceed as follows:

1.Shut down the PC.

2.In the display OSD, browse to the Settings menu.

3.Select the function Preferred Input Freq.

4.Select 45 Hz as vertical frequency.

5.Exit the OSD.

6.Reboot the computer.

After reboot, the signal from the graphic board should now be visible on the display.

90