Attaching the display to an arm
Attaching the display to an arm
The panel, standard attached to the tilt & swivel foot, is
compatible with the VESA 100 mm standard. So it can be used with an arm stand according to the VESA 100 mm standard.
Therefore, the tilt & swivel foot must be removed from the panel.
Important:
•Use an arm that is approved by VESA (according to the VESA 100 mm standard).
•Use an arm that can support a weight of at least 13 kg (28.66 lbs).
To attach the display to an arm stand:
1.Put the display face down on a clean and soft surface. Be careful not to damage the panel screen.
2.Remove the tilt & swivel foot cover.
3.Remove the small screw (A) fixing the small plastic cover on top of the foot. Next, remove the small cover itself.
B
A
Figure 17: Display with tilt & swivel foot cover removed
47