Allied Telesis AT-MC601 manual Upstream/Downstream, Actual Mbps, Min Mbps, Max Mbps, Status

Configuration

The parameters on the Configuration screen are described below.

Upstream/Downstream

The upstream and downstream data transfer rate.

❑Actual (Mbps)

Displays the actual data transfer rate on the line. The software automatically detects this speed.

❑Min (Mbps)

Allows you to adapt the data transfer rate by setting a minimum speed.

❑Max (Mbps)

Allows you to adapt the data transfer rate by setting a maximum speed.

The maximum and minimum speeds in Mbps available in the pull-down menus are:

0.94	4.22
1.06	5.63
1.41	7.50
1.88	8.44
2.11	11.26
2.81	15.01
3.75	16.88 (upstream only)

Status

This field will display “Select speed to set” until you have selected data rates from the upstream and downstream pull-down menus and set the rates by clicking the Apply button. Then reports on the status of the attempt to configure the speeds selected from the upstream and downstream pull- down menus will appear in this field. A successful configuration attempt will cycle though the following status reports:

Looking for link status...

Checking signal/noise ratio

Loading a Configuration DS=1.41 US=2.81

(This report will keep repeating with progressively higher upstream and downstream values until the set rate or the highest possible rate has been achieved.)

Saving config on EEPROM - S Side Saving config on EEPROM - P Side Done

39