Avaya S8700 manual Enabling the Ipsi, Set the Ipsi Control of Port Networks field to enabled

Enabling the IPSI

Enabling the IPSI

1.Type change system-parameters ipserver-interface and press Enter.

2.On a duplicated server, the system displays the following screen. Verify that the primary control and the secondary control subnetwork addresses are correct.

change system-parameters ipserver-interface	Page 1 of 1
IP SERVER INTERFACE (IPSI) SYSTEM PARAMETERS
SERVER INFORMATION
IPSI Host Name Prefix: birch
Primary Control Subnet Address: 198.152.254. 0 *
Secondary Control Subnet Address: 198.152.255. 0 *
OPTIONS
Switch Identifier: A
IPSI Control of Port Networks: enabled

The control subnetwork addresses typically match the most significant three octets of the IP addresses of the server for the media gateway. The most significant three octets are the first three groups of digits in the IP address. Select the configure server command on the Maintenance Web Interface to see the IP address of the server.

An asterisk (*) to the right of the Control Subnet Address field means that Communication Manager does not have the subnetwork information and the subnetwork address displayed is incorrect.

3.If the information in the Primary Control Subnet Address field, the Secondary Control Subnet Address field, or both fields is incorrect, use the Maintenance Web Interface to change the server configuration to match the Server IP address in configure server. Under Server Configuration and Upgrades, click Configure Server to change the server configuration. Then return to this procedure.

4.Set the Switch Identifier field to the switch ID letter. Acceptable switch ID letters are A through J. A is the default setting.

5.Set the IPSI Control of Port Networks field to enabled.

6.Press Enter to save the changes.

Installing and Configuring the Avaya S8700-Series Server January 2008 53