Dell E08J Series owner manual Installing a Power Supply Module

Page 40

NOTE: The Service action required indicator lights amber when there is a fault in the power supply module.

2.Disconnect the power cable from the power source and the power supply module you intend to remove and remove the cables from the cable securing strap.

3.Pull and rotate the two release levers away from the chassis until the power supply module is free from the slot.

4.Hold the power supply module and slide the power supply out of the chassis.

Figure 26. Removing and Installing the power supply module

1. power supply

2. release latch (2)

Installing A Power Supply Module

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.

Ensure that the power switch on the power supply module that you are installing, is in the off position.

1.Slide the new power supply module into the chassis until the power supply module is fully seated.

2.Rotate both the release lever toward the chassis until the power supply module locks into place.

3.Connect the power cable to the power supply module and plug the cable into a power outlet.

40

Image 40
Contents Dell PowerVault MD3860f Storage Arrays Page Contents Troubleshooting your system Technical Specifications Getting help Introduction Dell PowerVault Modular Disk Storage ManagerRelated Documentation Front-Panel Features Front-Panel FeaturesFront-Panel Indicators Front-Bezel IndicatorsBlue Back-Panel Features Back-Panel FeaturesCooling Fan Module LED Indicator Codes Cooling Fan Module IndicatorsPower Supply Module Features And Indicators Power Supply Module Features and Status IndicatorsPhysical-Disk LED Indicators Physical-Disk LED IndicatorsFrom the system Controller Modules RAID Controller ModulesHost Channel LED Link Rate Indications SFP+ Transceivers Fibre Optic And SAS Cables Fibre Optic Cable ConnectionMD3060e Expansion Module Features And Indicators Expansion Controller ModulesBattery Backup Unit RAID Controller Module-Additional FeaturesStorage Array Thermal Shutdown System Password Reset Installing The Front Bezel Removing And Installing The Front BezelRecommended Tools Physical-Disk Drawers Service Action Allowed Indicator LEDRemoving The Front Bezel Opening The Physical-Disk Drawer Inside the Physical-Disk DrawerClosing The Physical-Disk Drawer Removing The Physical-Disk DrawerPage Installing The Physical-Disk Drawer Removing and Installing the Physical-Disk DrawerPhysical Disks Physical Disk Installation GuidelinesRemoving a Physical Disk From a Physical-Disk Carrier Inch physical drive cage Guide pin Release handle Installing a Physical Disk In a Physical-Disk Carrier Removing a Physical Disk From a Physical-Disk Drawer Installing a Physical Disk In a Physical-Disk Drawer SAS Chain CablesRemoving The SAS Chain Cables Installing The SAS Chain Cables Removing and Installing the SAS Chain CablesRemoving a RAID Controller Module Or Expansion Module Installing a RAID Controller Module Or Expansion Module Opening The RAID Controller Module Closing The RAID Controller ModuleReplacing The SFP+ Transceiver Replacing the SFP+ TransceiverRAID Controller Module Backup Battery Unit Removing The RAID Controller Module Backup Battery UnitInstalling The RAID Controller Module Backup Battery Unit Power SuppliesRemoving a Power Supply Module Installing a Power Supply Module Removing and Installing the power supply moduleCooling Fan Modules Removing a Cooling Fan ModuleInstalling a Cooling Fan Module Removing and Installing the Cooling Fan ModuleTroubleshooting Loss Of Communication Troubleshooting An SFP+ TransceiverRemoving an SFP+ Module Troubleshooting External Connections Troubleshooting Power Supply ModulesTroubleshooting Array Cooling Problems Troubleshooting Expansion Enclosure Management ModulesTroubleshooting RAID Controller Modules Troubleshooting Physical DisksIf The Link Status LEDs Are Not Green If Both LEDs For Any Given FC in Port Are UnlitTroubleshooting Array And Expansion Enclosure Connections Troubleshooting a Wet Storage ArrayTroubleshooting a Damaged Array Controller Failure ConditionsCritical Conditions Noncritical ConditionsPCI Errors ECC ErrorsInvalid Storage Array Technical Specifications Page Tested Page Contacting Dell Locating your system service tagDocumentation feedback