Lathem 800P manual

Page 22

800P TruAlign Time Recorder User Guide

Function 13 – Set Print Intensity

When prompted to select the intensity of the imprint on the timecard, press the SET button to accept the factory setting. The ‘Confirmation Beep Disable/Enable’ function (14) will display next.

Note: Normally you would press the SET button to by pass the Set Print Intensity function.

For more information see:

Appendix B - Changing the Print Intensity

Page 23

Image 22
Contents TruAlign Time Recorder Disclaimer Table of Contents Features IntroductionOptional Accessories About this ManualPacking Contents Recommended Installation ToolsQuick Easy Setup Wall Mount StepQuick Easy Setup Table Top Mount Time=U.S. Eastern Time Daylight Savings=OnSetup Remove the Back-PlateProgramming the 800P AM 1 1 0 PM0 1 0 Page Function Settings Selections Factory Settings Press the or button until the display shows ‘10’ Step Press the or button until the display shows ‘09’ Page Press the or button until the display shows ‘24’ 10 1 10 2 Press the or button until the display shows ‘2’ 12 E 12 F Page 14 n 14 y Page Wall Mount Wall Using the Time Recorder Front ViewHow to change the print intensity on the timecard Appendix a Changing the Print IntensityHow to calibrate the TruAlign function Appendix B Calibrating the TruAlign FunctionCAL 800P TruAlign Time Recorder User Guide Appendix C Testing the Print Head Appendix D Changing the dates for Daylight Savings Appendix E Disable Daylight Savings Correction Frequently Asked Questions Specifications Minutes to 1/100s of Hour Warranty Specifications