Lathem 800P manual Appendix C Testing the Print Head

Page 32

800P TruAlign Time Recorder User Guide

Appendix C - Testing the Print Head

When should I run the test on the print head?

If you notice that the imprint on the timecard appears to be missing segments, you can test the print head to make sure it is working correctly.

To test the print head, see the instructions below.

￿Enter the ‘Setup Mode’. See Page 13.

￿Press the SET button until you get to Function 15 Example: Set the print test to 4 imprints

Function #

Print Head

Test

15:0

15:4

Step 1

Press the ￿ or - button until the display shows ‘4’. Note: Any value between 2 and 9 puts the time recorder into print head test mode.

Step 2

Press the SET button when the setting is correct. The time recorder will be in the print head test mode.

Note: If you scroll past the setting you wish, continue pressing the ￿ or - button until the desired setting displays, then press the SET button.

Step 3

With the time recorder in a normal time/date display. Insert a timecard and make an imprint. The imprint should look similar to the example.

Make 3 additional imprints, after the 4th imprint the time recorder will have completed the ‘print head test mode’ and be ready to imprint on the timecards normally.

Page 33

Page 31 Page 33
Image 32
Page 31 Page 33
Contents TruAlign Time Recorder Disclaimer Table of Contents Features IntroductionOptional Accessories About this ManualPacking Contents Recommended Installation ToolsQuick Easy Setup Wall Mount StepQuick Easy Setup Table Top Mount Time=U.S. Eastern Time Daylight Savings=OnSetup Remove the Back-PlateProgramming the 800P AM 1 1 0 PM0 1 0 Page Function Settings Selections Factory Settings Press the or button until the display shows ‘10’ Step Press the or button until the display shows ‘09’ Page Press the or button until the display shows ‘24’ 10 1 10 2 Press the or button until the display shows ‘2’ 12 E 12 F Page 14 n 14 y Page Wall Mount Wall Using the Time Recorder Front ViewHow to change the print intensity on the timecard Appendix a Changing the Print IntensityHow to calibrate the TruAlign function Appendix B Calibrating the TruAlign FunctionCAL 800P TruAlign Time Recorder User Guide Appendix C Testing the Print Head Appendix D Changing the dates for Daylight Savings Appendix E Disable Daylight Savings Correction Frequently Asked Questions Specifications Minutes to 1/100s of Hour Warranty Specifications
Top Page Image Contents