Lathem 800P manual Cal

Page 30

800P TruAlign Time Recorder User Guide

Function #	TruAlign
	Calibration

15:1

C A L 1

CAL 1

Press the or - button until the display shows ‘1’. Selecting ‘1’ activates the TruAlign calibration mode. Press the SET button.

The display will show ‘CAL 1’, insert and visually align a timecard, see Figure 1.

With the timecard fully inserted and properly aligned, press and hold the button to register the alignment.

Note the value showing on the display. Shift the card slightly left and right, the value will increase or decrease.

When the display is at the smallest value, release the button, the display will show ‘CAL2’.

Remove the timecard.

Proper alignment when the indicator falls in the middle of print area.

Figure 1

Page 31

Image 30

Contents TruAlign Time Recorder Disclaimer Table of Contents Features IntroductionOptional Accessories About this ManualPacking Contents Recommended Installation ToolsQuick Easy Setup Wall Mount StepQuick Easy Setup Table Top Mount Time=U.S. Eastern Time Daylight Savings=OnSetup Remove the Back-PlateProgramming the 800P AM 1 1 0 PM0 1 0 Page Function Settings Selections Factory Settings Press the or button until the display shows ‘10’ Step Press the or button until the display shows ‘09’ Page Press the or button until the display shows ‘24’ 10 1 10 2 Press the or button until the display shows ‘2’ 12 E 12 F Page 14 n 14 y Page Wall Mount Wall Using the Time Recorder Front ViewHow to change the print intensity on the timecard Appendix a Changing the Print IntensityHow to calibrate the TruAlign function Appendix B Calibrating the TruAlign FunctionCAL 800P TruAlign Time Recorder User Guide Appendix C Testing the Print Head Appendix D Changing the dates for Daylight Savings Appendix E Disable Daylight Savings Correction Frequently Asked Questions Specifications Minutes to 1/100s of Hour Warranty Specifications