Mitsubishi Electronics HS-S8300E(BRS) Alarm Recording Connection, 1st VCR, 2nd VCR

ALARM RECORDING

It is possible to switch from all recording modes to the 3H - L24H recording mode by applying an alarm signal to the SET IN terminal on the rear panel.

ALARM SET INPUT

3H - 960H, 0H	3H	3H - L24H
RECORDING	RECORD-	RECORDING
	ING
	15sec
NORMAL mode		ALARM mode

3H - 960H, 0H

RECORDING

NORMAL mode

•It is possible to switch to the alarm recording by ap- plying the set signal from the alarm sensor during re- cording in 3H,L12H, L24H, 48H - 960H or 0H mode.

•Set the alarm recording mode and alarm recording period with the “RECORDING SET UP” menu. (See page 10.)

•The index signal is automatically recorded when an alarm recording begins. (INDEX indicator flashes on the fluorescent display.)

•To record the index signal, the first 15 seconds of the alarm recording are in 3H mode.

•While the index signal is being recorded (for 15 seconds), if another set signal is applied to the SET IN terminal, it will not trigger a new alarm recording.

	ALARM RECORDING CONNECTION
Alarm set	External alarm lamp	• The alarm can be confirmed from a distance by
switch	or buzzer
		connecting the ALM (ALARM) OUT terminal to
		an existing alarm system panel or other external
		devices such as a buzzer.

SET	RST	REC	GND	ALM	MODE	CLK	CALL
	IN					OUT	RESET

IN OUT

S-VIDEO

MIC	IN	OUT	IN	REMOTE
		AUDIO		OUT
				VIDEO

Alarm reset switch

EXTERNAL TIME CLOCK ADJUSTMENT

*1

SET	RST	REC	GND	ALM	MODE	CLK	CALL
	IN					OUT

1st VCR

SET	RST	REC	GND	ALM	MODE	CLK	CALL
	IN					OUT

2nd VCR

If the “ALARM REC DURATION” of the “RECORDING SET UP” menu is set to other than “MAN1”, the on-screen clock can be reset to the nearest hour, by applying a signal to the RST (RESET) IN terminal. For example, if the current time is 11:29:59, it will be reset to 11:00:00; and if the current time is 11:30:00, it will be reset to 12:00:00.

*1: When connecting the MODE terminal of the 1st VCR with RST (RESET) IN terminal of the 2nd VCR and if the “MODE OUT” of the “REAR TERMINAL” menu is set to “CLOCK ADJ”, the on-screen clock of the 2nd VCR will automatically be adjusted to that of thet1s VCR.

22