OPERATION (continued)
B C D E
MENU | FUNC1 | FUNC2 | ENTER |
/SET | |||
FILE | W.BAL | GAIN | SHUTTER |
F |
|
|
|
WHITE PAINT |
| IRIS | |
R | B | AUTO/MANU | |
|
|
| M |
MASTER BLACK | IRIS | ||
O
N
CLOSE OPEN
oLENS IRIS CONTROL
●Operates the iris of the lens mounted on the camera.
Auto iris
1.Press IRIS AUTO/MANU button M to set to the auto iris mode (the IRIS MANU LED is not lit).
2.Set whether to adjust the auto iris level using the IRIS control N at AAUTO IRIS LEVELB.
(AREMOTE CONTROLLER OPERATION MODE SETTINGSB (A pg. 18))
●If the camera’s LENS switch is set to AMANUB, the auto iris will not function.
IRIS
AUTO/MANU
Switch between auto and manual.
IRIS
CLOSE 
OPEN
NOTE:
When Gain in set to AALC + EEIB or AALCB, or when the shutter mode is set to AEEIB, the iris mode is automatically set to auto iris. In this case, manual iris operation is not possible.
When the above settings have been set, change the setting at ALC IRIS SET to perform manual iris operation.
(A pg. 18, AREMOTE CONTROLLER OPERATION MODE SETTINGSB)
oMASTER BLACK LEVEL CONTROL
●Controls the black level of the camera signal.
●Use the MASTER BLACK control O to adjust the black level.
●Turn clockwise to increase the black level; turn counterclockwise to decrease the level.
oSCENE FILE FUNCTION
●To store setting data in the Scene File (A/B) or to call up data stored in the Scene File (A/B) and apply it to the connected camera.
Writing data into Scene File
1.Press FILE button F.
●The AFILEB screen will appear on the LCD.
FILE
SCENE A WRITE
FILE
Press FILE button.
2.Press FUNC1 button C to select either SCENE A or SCENE B.
Select either the
ASCENE AB or ASCENE BB: 
FUNC1
3.Press FUNC2 button D to select AWRITEB.
Set to AWRITEB.
FUNC2
Auto iris mode: serves as a precise auto iris level control. Manual iris mode: serves as an iris level control.
Manual iris
1.Press IRIS AUTO/MANU button M and set to the manual iris mode. (The IRIS MANU LED is lit.)
2.Using IRIS control N, the iris level can be controlled (between near CLOSE position and OPEN position).
4.Press ENTER/SET button E.
●The LCD shows ASCENE FILE A (or B) WRITE OK?B
SCENE FILE A
WRITE OK?
5.Press ENTER/SET button E again if it’s OK. ● The LCD changes to ASCENE FILE A (or B)
WRITING!B. The setting data is stored in memory. ● If you don’t want to execute writing. press
MENU button B to cancel.
SCENE FILE A
WRITING!