REMOTE CONTROLLER OPERATION MODE SETTINGS
●The following settings are possible based on the remote controller operation mode.
●AUTO IRIS LEVEL MODE
●ALC IRIS SET MODE
●CAMERA TYPE
Feature descriptions
oAUTO IRIS LEVEL
●In AUTO IRIS mode, when AUTO IRIS LEVEL adjustment using iris knob N is not required, AUTO IRIS LEVEL will be set to OFF. (Normally set to ON)
oALC IRIS SET
●In ALC or EEI mode, when MANUAL IRIS LEVEL adjustment using iris knob N is required, AUTO IRIS SET MODE will be set to OFF. (Normally set to AUTO)
oCAMERA TYPE
●By setting a camera type suitable for the connected camera, the shutter speed value during V.SCAN will be displayed correctly.
Setting Procedures
CONTRAST | ON |
OPERATE | A |
| OFF |
2.Select AUTO IRIS LEVEL, ALC IRIS SET and
B |
| D E |
| CAMERA TYPE using MENU button B. | ||
|
|
| ENTER |
| Select the item to be |
|
MENU | FUNC1 | FUNC2 | /SET |
| set. | MENU |
|
|
|
|
| ||
|
|
|
|
|
| |
FILE | W.BAL | GAIN | SHUTTER |
|
|
|
| FOCUS |
|
|
|
| |
NEAR |
|
| FAR |
| 3. Select feature of each item using FUNC2 | |
| SLOW | FAST |
| J | ||
|
| button D. |
| |||
|
|
|
|
|
| |
●It will not be set to remote controller by
MASTER BLACK | IRIS | selection only. |
N
CLOSE OPEN
1.While pressing ENTER/SET button E and FOCUS FAR button J, set the OPERATE switch A to ON.
●The setting screen of AUTO IRIS LEVEL will be displayed on the LCD screen.
AUTO IRIS LEVEL
ON
Select the feature to be set.
FUNC2
4.After completing the selection, press ENTER/ SET button E.
●AINITIALIZEB will be displayed on the LCD screen and each setting is enabled.
ENTER
Set the OPERATE |
| ENTER |
switch to ON while |
| /SET |
pressing the SET |
|
|
Press the SET key after the setting is complete
/SET
button |
NOTE:
If the OPERATE switch A is set to ON while pressing only ENTER/SET button E, only AUTO IRIS LEVEL setting is possible.
5.After the initial operation is complete, it will return to normal operation mode.