JVC XV-NA7SL manual Connection to a TV equipped with an S-video jack

Getting started

Connection to a TV equipped with an S-video jack

If your TV has an S-VIDEO input, you can get better picture quality by connecting it with the S-VIDEO output of the unit using an S-video cable instead of connecting the video input of the TV to the VIDEO jack of the unit.

											In this connection, set the VIDEO
The unit											SIGNAL SELECTOR to "Y/C."
AUDIO OUT		DIGITAL OUT	VIDEO OUT								AV OUT
		PCM / STREAM	VIDEO				VIDEO SIGNAL SELECTOR
				COMPONENT
SUBWOOFER	LEFT	COAXIAL OPTICAL				COMP.	PAL	COMPONENT	VIDEO
			Y	PB	PR		Y/C	REMOTE	/S-VIDEO
CENTER	RIGHT					/RGB			/AV OUT		In this connection, set the NTSC/
								NTSC	PAL	AV COMPU LINK
											REMOTE/PAL switch set to "PAL."
REAR			S

VIDEO SIGNAL SELECTOR		TV
		IN
Red White		S-VIDEO
S-video cable (not supplied)	White	VIDEO
		LEFT
		AUDIO
Audio cable (supplied)		RIGHT
	Red

NOTES

•Connect the unit to a PAL TV or multi-scan TV.

•Even if cables are connected to both the VIDEO OUT jack and S-VIDEO jack, video signal will only be transmitted from the port selected by the settings.

•You must change the switch position while the unit power is off. Otherwise, the changed setting is not effective.

To connect to a TV with the SCART connector

You can enjoy using the unit by simply connecting it to your television set with a 21-pin SCART cable. To hear audio sound with better quality, connect the AUDIO output to your audio equipment.

SCART cable

(Not supplied)

In this connection, make sure that the NTSC/ REMOTE/PAL switch set to "PAL."

Getting started

The unit

AUDIO OUT		DIGITAL OUT	VIDEO OUT							AV OUT
		PCM / STREAM	VIDEO				VIDEO SIGNAL SELECTOR
				COMPONENT
SUBWOOFER	LEFT	COAXIAL OPTICAL				COMP.	PAL	COMPONENT	VIDEO
			Y	PB	PR		Y/C	REMOTE	/S-VIDEO
						/RGB			/AV OUT
CENTER	RIGHT							NTSC	PAL	AV COMPU LINK
REAR		FRONT	S-VIDEO

NTSC/REMOTE/PAL Switch

TV

IN

AV

S-VIDEO

VIDEOIN

LEFT

AUDIO

RIGHT

Set the VIDEO SIGNAL SELECTOR correctly according to your TV

•If the TV only accommodates the composite video signal, set the switch to "COMP./RGB."

•If the TV accommodates Y/C signals, set the switch to "Y/C" so that you can enjoy better-quality pictures.

•If the TV accommodates RGB signals, set the switch to "COMP./RGB," and set the unit to supply RGB signals using the procedure shown below.

If you connect the unit to a PAL TV, set the NTSC/REMOTE/PAL switch to "REMOTE" and select PAL system from the remote control unit (see page 9).

7