JVC XV-NA7SL manual Picture, Audio

Additional information

Additional information

PICTURE

Symptom	Possible cause	Remedy
No picture is displayed on the monitor.	Connection of video cable is incorrect.	Connect the cable correctly.
	Input selection of TV is incorrect.	Select correctly.
	Disc is not playable.	Use a playable disc (see page 4).
No picture is displayed on the monitor or	The unit is in the progressive scanning	Make the Progressive scanning mode
the screen is blurred or divided into two	mode (i.e. the PROGRESSIVE indicator is	inactive by using the VFP - PROGRESSIVE
parts.	lit) through it is connected to a TV via the	SCAN button (see page 10).
	VIDEO or S-VIDEO jack.
The picture is noisy or blurred.	The unit is connected to a VCR directly	Connect the unit so that the picture signal
	and the copyguard function is activated.	flows directly to the TV.
	With some discs, the picture may be	Set [STILL MODE] to [FIELD] (see page
	blurred when [STILL MODE] is set to	59).
	[FRAME] or [AUTO].
No picture is displayed when connected	The VIDEO SIGNAL SELECTOR on the	Set the VIDEO SIGNAL SELECTOR on the
to a TV with the VIDEO OUT jack, S-VIDEO	rear panel is not set correctly.	rear panel to "PAL" while the unit is
jack or SCART connector.		turned off (see page 7).
No picture is displayed when connected		Set the VIDEO SIGNAL SELECTOR on the
to a TV with the COMPONENT VIDEO		rear panel to "NTSC" while the unit is
OUT jacks.		turned off (see page 8).
The picture does not fit the television	[MONITOR TYPE] is not set correctly.	Select monitor type correctly (see page
screen.		59).
	TV settings are incorrect.	Set the television correctly.
The upper and lower parts of the	It depends on the setting on the TV.	Adjust the TV screen using the controls
preference display are cut off when using		on the TV.
wide-aspect TV.
AUDIO
Symptom	Possible cause	Remedy
No audio is reproduced.	Connection is incorrect.	Check the connection.
	Input selection of amplifier is incorrect.	Select correctly.
No audio is reproduced when playing	Audio signal is not emitted from the unit’s	Use AUDIO OUT when playing back such
back a DVD disc recorded with high	DIGITAL OUT (see page 60).	discs.
sampling frequency (88.2 kHz or more)
linear PCM audio using the DIGITAL OUT
jack.
Audio volume is low when playing back	The audio level recorded on a DVD VIDEO	Turn up the volume of the TV or amplifier/
with the unit, compared with the TV or	is lower compared with a TV broadcast.	receiver.
VCR.		Remember to turn the volume back down
		before switching back to a TV broadcast
		to prevent a sudden burst of high-volume
		sound.
Sound is distorted or noise is generated.	Disc is dirty.	Wipe the disc surface (see page 5).
[MULTI CH] is shown in the display	The track is prohibited from down-mixing	Listen in multichannel surround audio.
window when playing back DVD AUDIO	to 2-channel stereo audio.
disc.

72