Hitachi CMP307XU Operating Instructions, Turning Power On and Off, Indicating lamp Power status

Page 15

OPERATING INSTRUCTIONS

Turning Power On and Off

To turn on the set power supply, set the MAIN POWER switch ( ) of the main unit to ON and then press the SUB POWER button ( ) or the POWER button of the remote control.

To turn off the set power supply, press the SUB POWER button () of the main unit or the POWER button of the remote control, then set the MAIN POWER switch () to OFF.

For normal operations, leave the main power switch () set to ON and use the sub power button or the Power button of the remote control to turn the power on and off.

The indicating lamp lights when the power is turned on.

ENGLISH

Indicating lamp

Power status

 

 

Lit in red

OFF

 

 

Lit or flickering in green

ON

 

 

Set unit

When the indicating lamp blinks in green or the message “POWER SAVE” or “OUT OF FREQUENCY” appears on the screen, there is something unusual about the status of reception. See “Symptoms That Seemingly Appear to be Failures.” 26

Main power switch

POWER

Remote controller

TIPS

Avoid repeatedly turning the monitor on and off at short time intervals.

Failures might result from such operation.

Turn off the main power switch ( ) before leaving the monitor out of use for an extended period of time.

If a power failure occurs while the set is running, it would be powered on upon recovery from the failure. Turn off the unit main power switch before leaving the set.

13

Image 15
Contents Plasma Inch High Definition Plasma Display Large-screen, high-definition plasma display panel FeaturesContents Safety Guidelines Do not touch the power plug when lightning is close to you Do not damage or modify the power cordEnclosed power cord must be used Be careful of power cord connectionRemove the power cord for complete isolation When you disconnect the power plugDo not put the monitor in high temperature atmosphere Do not bundle the power cordFCC Federal Communications Commission Statement Warning PrecautionsInstallation Instructions Component Names Installation InstructionsRear Monitor rear panel Installation and Cabling Connecting to the PCVideo equipment Connecting to Video EquipmentHandling the Remote Controller Loading BatteriesDegrees degrees About 5m Turning Power On and Off Indicating lamp Power statusOperating Instructions Sub input Volume AdjustmentVolume Input SelectionSound Mute Contrast AdjustmentInput Signal Status Display Adjustment status guidanceBrightness On-Screen Display System, EasyMenuMain Menu Picture Sound Display Function Picture Menu ContrastMenu item Selected Adjustment Setup hint Adjustment Item ListSharpness Mute VolumeColor TintMenu item Selected Adjustment NTSC,PAL,SECAM EnglishSwitching inputs Setting an unusedSets to Skip Sets to Select Accelerate switching Do not select when Select whenOther Features Automatic StoreDisplay Registration condition Status Display Example Reset Settings InitializationSignal Check Display menu itemSQ.W Switching the Display MethodSound Mode Power Save ModeTroubleshooting Symptoms That Seemingly Appear to be FailuresSymptom Point to check Example SymptomFine pattern flickers when displayed on the screen display Display image appears flowing display 2 RGB inputGeneral Specifications Product SpecificationsGND Signal InputPin Input signal Sync signal type PriorityXGA Recommended Signal ListResolution Horizontal Dot clock Remarks