Hitachi CMP307XU manual Input Selection, Volume Adjustment, Sub input, BNC input

Page 16

OPERATING INSTRUCTIONS (continued)

Input Selection

Press the RGB/VIDEO button on the remote controller or the unit to switch the input in the sequence of RGB1 RGB2 VIDEO1 VIDEO2 RGB1.

ENGLISH

The kinds of input for which SKIP has been selected with the on-screen display system, EasyMenu ( 21 ), are skipped.

Remote

RGB1

(D-sub input)

controller

 

 

RGB/

 

 

VIDEO

RGB2

(BNC input)

 

Set unit

VIDEO1

(composite or S input)

 

 

RGB/VIDEO

 

 

 

VIDEO2

(COMPONENT input)

Volume Adjustment

While the on-screen display system, EasyMenu ( 16 ) is not on display, press the remote

controller VOLUME button or (or the unit VOLUME button or to adjust the sound volume.

The adjustment status will be displayed as guidance while you press these buttons.

While the guidance is on display, press or to turn up the volume.

While the guidance is on display, press or to turn down the volume.

You can also adjust the sound volume setting via the on-screen display system, EasyMenu 16

The sound volume adjustment mode will exit when no keys are entered for 5 seconds. (The adjustment status guidance will disappear automatically.)

Remote controller

VOLUME

Set unit

[ VOLUME ]

Sound volume setting

VOLUME : 30

Adjustment status guidance

14

Image 16
Contents Plasma Inch High Definition Plasma Display Features Large-screen, high-definition plasma display panelContents Safety Guidelines Do not damage or modify the power cord Enclosed power cord must be usedBe careful of power cord connection Do not touch the power plug when lightning is close to youWhen you disconnect the power plug Do not put the monitor in high temperature atmosphereDo not bundle the power cord Remove the power cord for complete isolationPrecautions FCC Federal Communications Commission Statement WarningInstallation Instructions Installation Instructions Component NamesRear Installation and Cabling Connecting to the PC Monitor rear panelConnecting to Video Equipment Video equipmentLoading Batteries Handling the Remote ControllerDegrees degrees About 5m Indicating lamp Power status Turning Power On and OffOperating Instructions Volume Adjustment VolumeInput Selection Sub inputContrast Adjustment Input Signal Status DisplayAdjustment status guidance Sound MuteOn-Screen Display System, EasyMenu Main Menu Picture Sound Display FunctionPicture Menu Contrast BrightnessAdjustment Item List Menu item Selected Adjustment Setup hintMute Volume ColorTint SharpnessMenu item Selected Adjustment English NTSC,PAL,SECAMSetting an unused Sets to Skip Sets to Select Accelerate switchingDo not select when Select when Switching inputsAutomatic Store Other FeaturesDisplay Registration condition Reset Settings Initialization Signal CheckDisplay menu item Status Display ExampleSwitching the Display Method SQ.WPower Save Mode Sound ModeSymptoms That Seemingly Appear to be Failures TroubleshootingSymptom Point to check Symptom Fine pattern flickers when displayed on the screen displayDisplay image appears flowing display 2 RGB input ExampleProduct Specifications General SpecificationsSignal Input Pin Input signalSync signal type Priority GNDRecommended Signal List ResolutionHorizontal Dot clock Remarks XGA