Hitachi CMP307XU Loading Batteries, Handling the Remote Controller, Degrees degrees About 5m

ENGLISH

INSTALLATION INSTRUCTIONS (continued)

Handling the Remote Controller

Loading Batteries

(1) Open the battery cover.

Slide the battery cover towards the arrow mark while pressing it.

(2) Load batteries.

Load two Size AA batteries included observing the correct polarities.

When replacing the batteries, always use the R6P AA (or SUM-3) type.

(3) Close the battery cover.

Slide back the battery cover towards the arrow mark.

Handling the Remote Controller

Use the remote controller within about 5 m from front of the unit’s

remote-control sensor and within 30 degrees on both sides.With in 30 With in 30

degrees degrees About 5m

12

	Do not use batteries of any kind not recommended for this product. Do
	not use new and old batteries together. The batteries could explode or
CAUTIONS	leak, resulting in fires, physical injury, or stains.
	When loading batteries, observe their correct polarities as marked on
	the product. If loaded in the wrong direction, the batteries could
	explode or leak, resulting in fires, physical injury, or stains.
	Do not drop or impact the remote controller.
	Do not splash the remote controller with water or put it on a wet object
	to avoid possible failures.
	Before leaving the remote controller out of use for an extended period
TIPS	of time, remove the batteries from it.
	If the remote controller begins to lack responsiveness, replace the
	batteries.
	Strong light such as direct sunlight impinging on the photoreceptor of
	the remote control can cause operational failure. Position this unit to
	avoid direct contact with such light.