Hitachi CMP307XU manual Reset Settings Initialization, Signal Check, Display menu item

Reset (Settings Initialization)

The Easy Menu shown to the right will be displayed when the
SELECT button is used to select DISPLAY and moreover	INITIALIZE?
DISPLAY INT is selected from the On-screen Display	YES NO
System Easy Menu 16 during RGB1/RGB2 input. If the

key (select Yes) of the SELECT button is pressed at this time, the user adjustment values in the table below for the signal currently being received will be deleted and the factory settings will be restored.

Pressing the key (select No) cancels deletion and returns the DISPLAY menu.

DISPLAY menu item

Horizontal position	H.POSITION
Vertical position	V.POSITION
Dot clock frequency	CLOCK
Dot clock phase	PHASE

ENGLISH

Signal Check

The status of signal reception is checked automatically and the result is displayed on the screen.

	Status	Display		Example
Signals are received		•The input terminal and the
normally.		horizontal and vertical frequencies		RGB1 [D-SUB]
		are displayed in a guidance image.
				H : 46.5kHz, V : 60Hz
			Eithe VIDEO1 or VIDEO2 is displayed
			on VIDEO input.
A sync signal could not be		•The guidance message “POWER
detected.		SAVE” is displayed for about 5
❋Also includes the status		seconds.		POWER SAVE
		•In the event of continued absence of
of the VESA-DPMS sync		a sync signal, the power indicating
signal.		lamp flickers and the monitor enters
		power save mode.
The input signal does not		•Displays OUT OF FREQUENCY.
meet display specifications		and the Guide. (After 5 sec. have		OUT OF FREQUENCY.
or erratic.		elapsed, the display darkens and
28	30	display continues until the correct
		signal is received.)

23