Runco CW-61, CW-50XA, CW-42HD manual LEFT/- and RIGHT/+, Volume Down and UP, Connectors

Page 16

Controls and Functions

5.LEFT/– and RIGHT/+

These enlarge or reduce the image and function as CURSOR ( / ) buttons in OSD mode.

6.VOLUME DOWN and UP

These adjust the volume and function as CURSOR ( / ) buttons in OSD mode.

7.MENU/ENTER

Press this button to access the On-Screen Display (OSD) controls. Press this button during the display of the main menu to go to a submenu. Also used to select a highlighted menu item or confirm a changed setting.

The Power on/off switch does not disconnect the plasma display

WARNING completely from the supply mains.

Connectors ➤

VIDEO AUDIO1

DVD/HD1

AUDIO2

DVD/HD2

PC/RGB

AUDIO 3

DVD/HD3

DVD/HD4

EXTERNAL CONTROL REMOTE

R

Y

Cb/Pb

R

Y Cb/Pb Cr/Pr

D-SUB

R

D-SUB

1

Cr/Pr

L

L

L

HDMI

HDMI

2

2

1

4

10

VIDEO

AUDIO1

DVD/HD1

AUDIO2

DVD/HD2

PC/RGB

AUDIO 3

DVD/HD3

DVD/HD4

EXTERNAL CONTROL

REMOTE

1

R

Y

Cb/Pb

R

Y

Cb/Pb

Cr/Pr

D-SUB

R

D-SUB

IN

OUT

Cr/Pr

L

L

L

HDMI

HDMI

2

(MONO)

(MONO)

(MONO)

3

5

6

7

8

9

Figure 2-2. CW-42HD Connector Panel

6	Runco CinemaWall Owner’s Operating Manual

Image 16

Contents CW-42HD CW-50XA Page Three Year Limited Warranty For Plasma DisplaysRIGHTS, Limits and Exclusions Runco INTERNATIONAL, INC Safety Precautions DOC Compliance NoticeTable of Contents Maintenance and Troubleshooting SpecificationsOperation Serial CommunicationsList of Figures List of Figures Introduction About This ManualUsing This Manual If you need Turn toDescription, Features and Benefits Key Features and BenefitsOptional Accessories Controls and Functions Controls and IndicatorsCinemaWall at a Glance Connectors Volume Down and UPLEFT/- and RIGHT/+ DVD/HD1 VIDEO1, 2 RCA, S-VideoPC/RGB 15-pin D-Sub CinemaWall Remote Control External Control 9-pin, male D-SubRemote in 3.5-mm mini phone jack, tip/ring/sleeve Remote OUT 3.5-mm mini phone jack, tip/ring/sleeveCursor Keys VIDDVD-HD VOL + / VOLDVD/HD Video 1Cursor OK / MenuMute Volume +12. / Exit Controls and Functions Remote Control InstallationOperation Other surfaces Quick Setup Step Procedure For Details, refer toInstallation ConsiderationsMounting the CinemaWall On a Wall or Table StandOther Considerations VentilationProlong operating life Connecting Connections toCinemaWall CinemaWall to SourceAudio Connections Refer to Computer/Video Signal Compatibility on page 52 forOutputs from your source components to these inputs RS-232 Controller ConnectionInstalling the Cable Clamps Cable ManagementInstallation Operation Turning on the PowerChanging the OSD Language Setting the PC Display Properties Using the On-Screen Menus Picture Adjust InstallSignal Info AudioPicture Adjust Main MenuTypical Pluge Pattern for Adjusting Brightness Gray Yellow Cyan Green Magenta Red Blue Gray Yellow Cyan Green Magenta Red Blue Typical Test Pattern for Adjusting Sharpness You must set the Advanced OSD option in the Function menu to SEL. ADJ. Exit Return Audio Aspect Ratio Settings Aspect Ratio DescriptionInstall Language Refer to Changing the OSD Language onSetting Blank Field to Gray makes it easier to see whether Power Turning Management PowerFunction When you turn on the Soften feature Last Mode Signal Info Operation Troubleshooting Tips Maintenance and TroubleshootingSymptom Possible Causes Solution Computer/Video Signal RS-232 Connection and Port Configuration Serial Command SyntaxSerial Communications Function Code DataSerial Communications Specifications CinemaWall SpecificationsWeight with Stand Regulatory Approvals Limited Warranty Specifications are subject to change without noticeDimensions CinemaWall Model CW-42HD DimensionsCinemaWall Model CW-50XA Dimensions CinemaWall Model CW-61 Dimensions Computer/Video Signal Compatibility Computer/Video Signal Compatibility ChartSUN Specifications Page RUMA-010975