Runco CW-50XA, CW-61, CW-42HD manual Operation, Turning on the Power, Changing the OSD Language

4. Operation

1.Turn on your source components.

2.Attach the two ferrite cores supplied with the display to each end of the AC power cable as shown in Figure 4-1.Doing so will reduce radio frequency interference (RFI) emissions to a level that conforms to FCC regulations. Use the supplied plastic bands to secure the cores in place.

4.1

Turning on the Power

Power cable

Ferrite Core

Ferrite Core

Figure 4-1. Attaching the Ferrite Cores to the Power Cable

3.Plug the female end of the power cord into the AC receptacle on the rear of the CinemaWall (AC 100V ~ 240V). Connect the other end to your AC power source.

4.Press the POWER button on the underside of the CinemaWall. The power indicator lights solid green.

5.After a brief warm-up period (approximately 10 seconds), the CinemaWall will display an image.

The CinemaWall OSD language is initially set to English, but can also display the menus in German (Deutsch), French (Français), Spanish (Español) or Italian (Italiano). To change the OSD language:

1.Press OK or MENU.

2.Select Install from the Main Menu.

3.Select Language from the Install Menu.

4.Press right- or left-arrow button ( or ) to highlight the desired language and press OK or MENU. The change takes effect immediately.

4.2

Changing the OSD Language

Runco CinemaWall Owner’s Operating Manual 23