Runco CW-42HD Installation, Considerations, Mounting the CinemaWall, On a Wall or Table Stand

Page 26

Installation

3.3

Proper installation of your CinemaWall will ensure the highest possible picture quality.

Installation

Whether you are installing the CinemaWall temporarily or permanently, you should take

Considerations

the following into account to ensure that it performs optimally.

 

 

Mounting the CinemaWall

To install the CinemaWall, you will need either an optional table stand or wall-mounting kit.

on a Wall or Table Stand

The CinemaWall cannot be installed on its own.

 

If you do decide to wall-mount the CinemaWall, ensure that the wall-mount bracket is

 

installed according to the instructions included with it. The wall must be capable of

 

supporting a redundant weight factor three (3) times the weight of the display, or be

 

reinforced.

 

 

Runco recommends that this be done by a custom installation specialist.

 

Note

Use only a Runco-approved wall-mount kit or table stand that is

 

specifically designed for your display.

You can attach your optional mounts or stand to the CinemaWall in either of two ways:

• While it is upright.

As it lies flat with the screen face down. Place the protective sheet, which was wrapped around the plasma monitor when it was packaged, between the screen and your work surface to avoid scratching or otherwise damaging the screen surface.

Ambient Light In general, minimize or eliminate light sources directed at the display. Contrast ratio in your images will be noticeably reduced if light directly strikes the display, such as when a shaft of light from a window or floodlight falls on the image. Images may then appear washed out and less vibrant.

16

Runco CinemaWall Owner’s Operating Manual

Image 26
Contents CW-42HD CW-50XA Page Three Year Limited Warranty For Plasma DisplaysRIGHTS, Limits and Exclusions Runco INTERNATIONAL, INC Safety Precautions DOC Compliance NoticeTable of Contents Operation Maintenance and TroubleshootingSpecifications Serial CommunicationsList of Figures List of Figures Introduction About This ManualUsing This Manual If you need Turn toDescription, Features and Benefits Key Features and BenefitsOptional Accessories CinemaWall at a Glance Controls and IndicatorsControls and Functions LEFT/- and RIGHT/+ Volume Down and UPConnectors PC/RGB 15-pin D-Sub VIDEO1, 2 RCA, S-VideoDVD/HD1 Remote in 3.5-mm mini phone jack, tip/ring/sleeve CinemaWall Remote ControlExternal Control 9-pin, male D-Sub Remote OUT 3.5-mm mini phone jack, tip/ring/sleeveDVD-HD Cursor KeysVID VOL + / VOLCursor DVD/HDVideo 1 OK / Menu12. / Exit Volume +Mute Controls and Functions Operation InstallationRemote Control Other surfaces Quick Setup Step Procedure For Details, refer toMounting the CinemaWall InstallationConsiderations On a Wall or Table StandProlong operating life VentilationOther Considerations CinemaWall ConnectingConnections to CinemaWall to SourceOutputs from your source components to these inputs Refer to Computer/Video Signal Compatibility on page 52 forAudio Connections RS-232 Controller ConnectionInstalling the Cable Clamps Cable ManagementInstallation Changing the OSD Language Turning on the PowerOperation Setting the PC Display Properties Using the On-Screen Menus Signal Info Picture AdjustInstall AudioPicture Adjust Main MenuTypical Pluge Pattern for Adjusting Brightness Gray Yellow Cyan Green Magenta Red Blue Gray Yellow Cyan Green Magenta Red Blue Typical Test Pattern for Adjusting Sharpness You must set the Advanced OSD option in the Function menu to SEL. ADJ. Exit Return Audio Aspect Ratio Settings Aspect Ratio DescriptionInstall Language Refer to Changing the OSD Language onSetting Blank Field to Gray makes it easier to see whether Function PowerPower Turning Management When you turn on the Soften feature Last Mode Signal Info Operation Symptom Possible Causes Solution Maintenance and TroubleshootingTroubleshooting Tips Computer/Video Signal Serial Communications RS-232 Connection and Port ConfigurationSerial Command Syntax Function Code DataSerial Communications Specifications CinemaWall SpecificationsWeight with Stand Regulatory Approvals Limited Warranty Specifications are subject to change without noticeDimensions CinemaWall Model CW-42HD DimensionsCinemaWall Model CW-50XA Dimensions CinemaWall Model CW-61 Dimensions Computer/Video Signal Compatibility Computer/Video Signal Compatibility ChartSUN Specifications Page RUMA-010975