Runco CW-50XA, CW-61, CW-42HD manual Computer/Video Signal

Page 54

Maintenance and Troubleshooting

Table 5-1. Troubleshooting Chart (continued)

Symptom

 

Possible Cause(s)

Solution

 

 

 

 

“Out of range” appears

The resolution and

• Select a compatible

on-screen.

 

frequency of the video

resolution and vertical

 

 

card in the computer are

frequency (refer to

 

 

not compatible with the

Computer/Video Signal

 

 

CinemaWall.

Compatibility on

 

 

 

page 52).

 

 

 

 

The image is too large or too

Image size needs

• Adjust the image size (refer

small.

 

adjusting.

to Image Options on

 

 

 

page 34).

 

 

 

 

44

Runco CinemaWall Owner’s Operating Manual

Image 54
Contents CW-42HD CW-50XA Page Three Year Limited Warranty For Plasma DisplaysRIGHTS, Limits and Exclusions Runco INTERNATIONAL, INC Safety Precautions DOC Compliance NoticeTable of Contents Operation Maintenance and TroubleshootingSpecifications Serial CommunicationsList of Figures List of Figures Introduction About This ManualUsing This Manual If you need Turn toDescription, Features and Benefits Key Features and BenefitsOptional Accessories Controls and Indicators Controls and FunctionsCinemaWall at a Glance Volume Down and UP ConnectorsLEFT/- and RIGHT/+ VIDEO1, 2 RCA, S-Video DVD/HD1PC/RGB 15-pin D-Sub Remote in 3.5-mm mini phone jack, tip/ring/sleeve CinemaWall Remote ControlExternal Control 9-pin, male D-Sub Remote OUT 3.5-mm mini phone jack, tip/ring/sleeveDVD-HD Cursor KeysVID VOL + / VOLCursor DVD/HDVideo 1 OK / MenuVolume + Mute12. / Exit Controls and Functions Installation Remote ControlOperation Other surfaces Quick Setup Step Procedure For Details, refer toMounting the CinemaWall InstallationConsiderations On a Wall or Table StandVentilation Other ConsiderationsProlong operating life CinemaWall ConnectingConnections to CinemaWall to SourceRefer to Computer/Video Signal Compatibility on page 52 for Audio ConnectionsOutputs from your source components to these inputs RS-232 Controller ConnectionInstalling the Cable Clamps Cable ManagementInstallation Turning on the Power OperationChanging the OSD Language Setting the PC Display Properties Using the On-Screen Menus Signal Info Picture AdjustInstall AudioPicture Adjust Main MenuTypical Pluge Pattern for Adjusting Brightness Gray Yellow Cyan Green Magenta Red Blue Gray Yellow Cyan Green Magenta Red Blue Typical Test Pattern for Adjusting Sharpness You must set the Advanced OSD option in the Function menu to SEL. ADJ. Exit Return Audio Aspect Ratio Settings Aspect Ratio DescriptionInstall Language Refer to Changing the OSD Language onSetting Blank Field to Gray makes it easier to see whether Power Power Turning ManagementFunction When you turn on the Soften feature Last Mode Signal Info Operation Maintenance and Troubleshooting Troubleshooting TipsSymptom Possible Causes Solution Computer/Video Signal Serial Communications RS-232 Connection and Port ConfigurationSerial Command Syntax Function Code DataSerial Communications Specifications CinemaWall SpecificationsWeight with Stand Regulatory Approvals Limited Warranty Specifications are subject to change without noticeDimensions CinemaWall Model CW-42HD DimensionsCinemaWall Model CW-50XA Dimensions CinemaWall Model CW-61 Dimensions Computer/Video Signal Compatibility Computer/Video Signal Compatibility ChartSUN Specifications Page RUMA-010975