3M 965DSP-B instruction manual Toolbox

Page 13

Toolbox

Use the [Up] and [Down] arrow key to move to the desired ‘tool’, then press the [Enter] key to accept the choice.

The Toolbox contains four additional functions:

•Self-Calibrate

•Load Coils

•Ohms to Distance

•Caller ID

Descriptions of these functions are found in the following pages.

The fifth item in the menu (Maintenance) is only used during 965DSP-B factory service.

13

Image 13

Contents Dynatel TM 965DSP-B Subscriber Loop Analyzer Page Table of Contents Out of Box Test Leads ScreenKeypad Editing Control KeysFunction Keys Welcome Screen SetupContrast UnitsVoltage Current Resistance Toolbox Self-Calibration Load Coils Ohms/Distance Caller ID Opens Edit Custom Calibrate to Cable Tone Page Separate Pair This is the preferred hookup RFL Resistance Fault LocatePage RFL Single Pair Page RFL Multi-section Setup RFL SetupPage Isdn Isdn Bit Error Test Page Noise LossWideband Loss Longitudinal BalanceInactive Pair AutoActive Pair Auto SetupDial Noise/Longitudinal Balance Dial LossOpens Cable Type Talk Set Talk Set Setup Charging Care and MaintenanceLevel of Charge AC/DC AdaptorReplacement Items Battery HolderTest Leads Repair Symptom Cause Solution Unit does not turn on965DSP-B Specifications New Product Limited Warranty