3M 965DSP-B Care and Maintenance, Charging, Level of Charge, AC/DC Adaptor, IR Port

Care and Maintenance

Battery Pack: The 965DSP-B uses a Nickel Metal Hydride (NMH) battery pack. Typical life of the battery pack is two years.

To change the battery pack: 1) loosen the six screws on the battery compartment door and remove the door, 2) remove the old pack , then 3) unplug the battery connector.

To install a new battery pack: 1) plug in the battery connector, 2) place the pack in the battery compartment, then 3) replace the door and tighten the screws.

Charging:

The battery pack must be charged on a regular basis. You can use the 965DSP-B for up to 12 hours typical usage (6 hours continuous usage).

The time between charges may be reduced if you use the backlight frequently or if you work in very cold weather.

Typical charging time is two hours.

Level of Charge:

The battery icon in the upper right of all screens indicates the battery charge. Four black “bars” indicate full charge. Zero black “bars” indicate the battery pack is very low and should be charged immediately.

AC/DC Adaptor:

Use the AC/DC adaptor to charge the NMH battery pack. Plug the AC cord into the AC/DC adaptor and into a power outlet. Plug the DC cord into the 965DSP-B.

IR Port:

The IR Port on the top of the 965DSP-B is used for uploading new software enhancements.

An IR to RS-232 adaptor cable is provided with software enhancements.

39