3M 965DSP-B instruction manual Tone

Page 21

Tone

Use this function to send a tone on a pair.

Use the [Up] and [Down] keys to select the desired tone. Note that the top tone on the list is always sent as an interrupted (beeping) tone. The other four tones are continuous tones.

Use the interrupted tone for Pair Identification. Use the continuous tones for measuring Loss by using a separate 965DSP or another instrument.

Press the [Enter] key to send the selected tone.

Press the [Up] and [Down] keys to adjust the volume of the tone heard in the 965DSP-B speaker. Note that the volume control does not affect the level of the tone sent on the pair.

21

Image 21

Contents Dynatel TM 965DSP-B Subscriber Loop Analyzer Page Table of Contents Out of Box Screen Test LeadsKeypad Editing Control KeysFunction Keys Welcome Screen SetupContrast UnitsVoltage Current Resistance Toolbox Self-Calibration Load Coils Ohms/Distance Caller ID Opens Edit Custom Calibrate to Cable Tone Page Separate Pair This is the preferred hookup RFL Resistance Fault LocatePage RFL Single Pair Page RFL Multi-section Setup RFL SetupPage Isdn Isdn Bit Error Test Page Noise LossWideband Loss Longitudinal BalanceInactive Pair AutoActive Pair Auto SetupDial Loss Dial Noise/Longitudinal BalanceOpens Cable Type Talk Set Talk Set Setup Charging Care and MaintenanceLevel of Charge AC/DC AdaptorBattery Holder Replacement ItemsTest Leads Repair Symptom Cause Solution Unit does not turn on965DSP-B Specifications New Product Limited Warranty