3M 965DSP-B instruction manual

Page 26

There are two possible single pair hookup errors: 1) the Fault is greater than 20M Ohms, or 2) the Red/Green strap is bad.

The screen will show the combination of errors that have been detected. Correct the errors and press the [Enter] key to repeat the test.

If the hookup test detects no errors, the 965DSP will go directly to the following results screen.

Press [Tab] to show readings in Ohms instead of distance. Press [Enter] to repeat the fault locate using the same Distance to Strap. Press [Setup] to go to the RFL setup screen.

The number in the lower right corner is the section number of the fault when Multiple Gauge is selected. The screen shows “1” for Single Section (Single or Separate Pair).

26

Image 26

Contents Dynatel TM 965DSP-B Subscriber Loop Analyzer Page Table of Contents Out of Box Keypad ScreenTest Leads Control Keys EditingFunction Keys Setup Welcome ScreenUnits ContrastVoltage Current Resistance Toolbox Self-Calibration Load Coils Ohms/Distance Caller ID Opens Edit Custom Calibrate to Cable Tone Page RFL Resistance Fault Locate Separate Pair This is the preferred hookupPage RFL Single Pair Page RFL Setup RFL Multi-section SetupPage Isdn Isdn Bit Error Test Page Loss NoiseLongitudinal Balance Wideband LossAuto Inactive PairAuto Setup Active PairOpens Cable Type Dial LossDial Noise/Longitudinal Balance Talk Set Talk Set Setup Level of Charge Care and MaintenanceCharging AC/DC AdaptorTest Leads Battery HolderReplacement Items Symptom Cause Solution Unit does not turn on Repair965DSP-B Specifications New Product Limited Warranty