Winegard RD-9946 Silver, Device Refer to , Page 14 for operation and installation, Gold

Page 11

Connect 75 ohm coaxial cable to SATELLITE IN jack on receiver.

Rev. 6/98

	TO RECEIVER
	TO RECEIVER
	BLUE/BLACK 13
	WHITE/BLACK 12
ORANGE/BLACK 11
	BLACK/WHITE 10
	WHITE 9
	BLUE 8
	ORANGE 7
	BLACK 6
	RED 5
	GREEN 4
	RED/WHITE 3
	RED/BLACK 2
	GREEN/BLACK 1
	REMOTE CONTROL		PANEL
	WINEGARD P/N:2750225		120 VAC 60 Hz 100 WATTS MAX

INDICATOR

WARNING IGN

TO ANTENNA

46 CM 60CM

ohm coaxial	antenna.
Connect 75	cable from
Connect 13 pin connector here, makeing sure wire colors match. Secure connector to positioner with screws molded into connector.

	After all other connections are made connect AC power cord to 120 VAC outlet.	Connecttovehicleground.
	Make sure switch is in the 46CM position. Switch removed 2/23/98.
		SILVER
		Device Refer to Figure 15, Page 14 for operation and installation.
	Optional RD-9911 Warning

Optional RD-9901 Remote Control Wall Plate. Connected by 25' telephone-type wire with modular plug-in connections.

Connecttoignition+12VDC.		This connection is optional. If used antenna will be put into travel position whenever the ignition is turned ON and there is AC power to the positioner.	Figure 12

GOLD

11

Image 11

Contents Winegard Not applicable to mount and antenna Important SafeguardsUnpacking/Inventory Table Of ContentsInstallation Requirements Rev 9/98 Satellite System, RD-9946 proceed to step InstallationDo not Caulk Mount Base Ring Page Rev /99 Rev /98 Connecttoignition+12VDC Device Refer to , Page 14 for operation and installationSilver Optional RD-9911 WarningPositioner To Receiver Control Wires To AntennaSensar TV Antenna Receiver CH 3/4 OUTPress UP/DOWN arrow buttons to get Park on screen Park Move to Last SatSearch DSS Park Press Select a or B as appropriatePositioner Rear Panel RD-9901 Remote Control Wall Plate InstallationRD-9901 Remote Control Wall Plate Telephone Cord Connect to ignition +12 VDC RD-9911 Warning Device Installation/OperationRCA cable Install two AA batteries provided Connect to vehicle groundDescription Use Cable Roof-thru Plate InstallationQTY Must Perform Must Perform Locating the Satellite Pinnacle RV Digital Satellite System Models RD-9946 Important Safeguards Table of Contents DSS Uplink Signal Programming Uplink Control CentersIntroduction / HOW does Digital Satellite TV WORK? For Programming information call Dish NetworkPress Select a Finding the Satellite Method Using the City MenuSystem Operation Finding the Satellites Select a City Enter ElevationEntry of the previous state Start Search QuitCalculating Press Left arrow button to scroll list to the lastSearching Level = Setting DetectorFine Tuning Azimuth Moving to StartPress Select a if correct satellite was found Fine Tuning ElevationSystem has found a satellite and is fine tuning the signal Correct Satellite Continue SearchPress Select B Enter elevation, Figure Finding the Satellite Method Entering the ElevationPress Select B if correct satellite was not found El Angle =Press Select B Enter Location, Figure Enter Elevation Enter LocationPress Select B Press UP arrow buttonTo decrease latitude by 1o Latitude =Longitude = Press Left arrow buttonLatitude and longitude Putting Antenna in Park Position Move to Last Sat Manual Move Move to Last SatelliteAz3 = El 3 = Manual MovementManual Move Edit XXX Press Select a to enter code Edit MenuEdit Search DSS Enter CodeEdit Select Search SatelliteSelect Search Sat Set Motor Positions 101.0Quit Add/Edit Search SatelliteInactive Edit Press Select a to enter new satellite as search satellite Winegard* 165.0 QuitWinegard* 165.0 Edit Press Select a to enter satellite into memoryPage Satellite Remote Panel OperationSearch For Satellite Search routine againParking the Antenna Page Pinnacle Positioner Switch was removed 2/16/98 Positioner Controls & IndicatorsProgrammed City Locations Environmental Conditions PowerWinegard Important Safeguards Introduction Lnbf No Satellite FoundAntenna Reflector at Look angle Coax Center Conductor Return To Defaults Press Select a Set to Defaults. See Figure Test Functions Return to DefaultsSet to Defaults Quit Memory Restored Press Any KeyPress Select B Park Name of search satellite Positioner Does Not RespondSearch Xxxxxx Park Test RD-9901 Remote Control Wallplate Press Select a Test Remote Panel Test LNB Test Remote PanelTest Remote Panel Elevation = Press Select B Test Remote PanelThree times Test Remote Panel Search LED = OnTest Remote Panel Search LED = Off Press UP arrow button twicePress Right arrow button twice Test Remote Panel Park LED = OnTest Remote Panel Park LED = Off Test Remote Panel Search Key PressedTest Remote Panel Park Key Pressed Test LNB Min. is Signal level, max. isAntenna = 0 dB Level = Press Select a Test LNBPositioner Does Not Come On Make sure switch is all Way left or right dependingPress either Select a or B Parking System, Fail Please CheckParking System Fail Please Check When Searching Positioner Displays Search Stopped Winegard Table of Contents Index Part Description QTY Number Antenna Support AssemblyMount Assembly Index Part Description Number Mount Base POSITIONER/ACCESSORIES ANTENNA/FEED Assembly Lnbf CABLE, Part Number For antenna mounts with a serial # of 10111 or higher