Winegard RD-9946 Remote Panel Operation, Search For Satellite, Search routine again

REMOTE PANEL OPERATION

Search LED - Lights when system has found satellite or when positioner is moving antenna

Search Button - When pressed system will search for satellite at elevation angle entered

Elevation Angle - Indicates elevation angle

Remote Control Panel

Model RD-9901

Figure 39

NOTE: All commands will be shown in bold with brackets, example [SELECT A].

The Remote Panel allows you to "hide" the positioner and still operate the system from the remote panel. Figure 39 shows the remote panel controls and operations.

NOTE: Remote Control Panel will not work if the positioner is performing/

accessing any menu. Example: City menu, Manual Movement, Edit Menu, etc.

Park LED - Lights when antenna is in park position or when positioner is moving antenna

Park Button - When pressed positioner will put antenna into park position

(+)Elevation Push Button(s) - When pressed increases number by 1

(-)Elevation Push Button(s) - When pressed decreases number by 1

Search For Satellite	To search for the satellite using the remote control proceed as follows:
	1.	Turn TV ON and tune to channel 3 or 4 (output channel of receiver).
	2.	Press [POWER] on receiver remote to turn satellite receiver on. Determine
	correct elevation angle by entering your locations ZIP code into receiver (refer
	to receiver manual).
	3.	On remote panel press [+/-]elevation buttons until you have the correct
	elevation angle, Figure 39.
	4.	Press [SEARCH] button to begin search function. Both LED's will light
	while antenna is moving. Only the search LED will light when the satellite is
	found.
	NOTE: If the wrong satellite was found, press [SEARCH] to start the
	search routine again.
	NOTE: If both LED's go out, the system has not found a satellite. Verify
	that you have entered correct angle, and there is a clear view of the
Rev. 1/97	satellite.

42