Winegard RD-9946 installation manual Manual Movement, Manual Move Edit, Az3 = El 3 =

MANUAL MOVEMENT

2.Press SELECT A or B as appropriate

NOTE: All commands will be shown in bold with brackets, example [SELECT A].

Manual Movement: This function allows you to manually move the antenna. This feature is not normally used. Since the satellite signals are digital, once the system acquires the signal, you cannot improve the picture, only increase the signal strength. To manually move the antenna, proceed as follows:

NOTE: To manually lower the antenna to the travel position, refer to the Troubleshooting Manual.

1.Press [UP/DOWN] arrow until Manual Move is displayed on positioner. See Figure 26.

2.Press [SELECT A or B] Manual Move, see Figure 26.

1.Press UP/DOWN arrow buttons to get Manual Move on screen

SELECT A

SELECT B

PINNACLE POSITIONER

by WINEGARD

Manual Move Edit

Model RD-9900

Figure 26
3.	Press [ARROW BUTTONS] to move antenna in desired direction/position,
see Figure 27. Figure 28 shows what the various numbers indicate on the
positioner display.
4. Press SELECT A to exit		3. Press RIGHT
	3. Press UP to raise antenna	to move antenna
Manual Move		to the right

SELECT A

SELECT B

PINNACLE POSITIONER

by WINEGARD

Az(3) = XXXXX
El (3) = XXXXX	XXX

Model RD-9900

Figure 27	3. Press LEFT	3. Press DOWN
	to move antenna
		to lower antenna
	to the left

35