Finding the Satellite
Method 3:
Entering the Latitude
and Longitude
One requirement must be met to fully enjoy automatic system TV viewing. The RV must be reasonably level. Any of the leveling indicators available should be adequate for this purpose. If the RV is not leveled, the system may not find the high power satellites.
After the RV has been leveled, proceed as follows:
NOTE: Winegard does not warrant this system to work outside the continental United States (latitude 25o to 50o, longitude 65o to 125o).
To find the satellite by entering the latitude and longitude for your location proceed as follows:
1. Turn TV ON and tune to channel 3 or 4 (output channel of receiver).
NOTE: SELECT A chooses top option, SELECT B chooses bottom option.
2. Press SELECT A
2.Press [POWER] on receiver remote to turn satellite receiver on.
3.On the positioner press [UP/DOWN] arrow button until Search DSS appears on the positioner screen, Figure 17.
1.Press UP/DOWN arrow buttons to get Search DSS on screen
SELECT A
SELECT B
PINNACLE POSITIONER
by WINEGARD
Search DSS Park
Model
Figure 17
4. Press SELECT B
4.Press [SELECT A] to enter the search function, Figure 17. (Press [SELECT B] if Search DSS is bottom option on screen.
5.Press [UP] arrow button, Figure 18.
3.Press UP arrow button
SELECT A
SELECT B
Enter Elevation Enter Location
PINNACLE POSITIONER
by WINEGARD
Model
Figure 18
6.Press [SELECT B] Enter Location, Figure 18
NOTE: If you do not know your latitude and longitude you can refer to
Figure 40, page 25.
30