Winegard RD-9946 installation manual Fine Tuning Elevation, Correct Satellite Continue Search

Page 27

System has found a satellite and is fine tuning the signal

SELECT A

SELECT B

PINNACLE POSITIONER

by WINEGARD

Fine Tuning

Elevation

Model RD-9900

Figure 10

9.Verify that system has found correct satellite (you will see a picture). Since DBS services use a digital signal and the satellites are only separated by 9o, the system can find the wrong satellite. Press [SELECT A] if correct satellite was found, Figure 11. You are now ready to watch satellite TV! If the wrong satellite was found, press [SELECT B] to continue the search.

If no satellite is found the message Satellite Not Found, Press Any Button, will be displayed by the positioner. Press any button to return to the menu shown in Figure 1, page 4.

7. Press SELECT A if correct satellite was found

SELECT A

SELECT B

Correct Satellite Continue Search

PINNACLE POSITIONER

by WINEGARD

Model RD-9900

Press SELECT B if correct satellite was not found

Figure 11

NOTE: If after two (2) tries you still get "Satellite Not Found" check that:

1.The antenna has a clear view of the satellite(s), no trees, buildings, etc. blocking the view. The satellite signal will not pass through solid objects.

2.Your receiver is turned ON.

3.The positioner is connected to the receiver correctly, refer to Installation Manual.

If after checking the above, you still do not find a satellite refer to the

Troubleshooting Manual.

Rev. 2/97

27

Image 27
Contents Winegard Not applicable to mount and antenna Important SafeguardsUnpacking/Inventory Table Of ContentsInstallation Requirements Rev 9/98 Satellite System, RD-9946 proceed to step InstallationDo not Caulk Mount Base Ring Page Rev /99 Rev /98 Connecttoignition+12VDC Device Refer to , Page 14 for operation and installationSilver Optional RD-9911 WarningPositioner To Receiver Control Wires To AntennaSensar TV Antenna Receiver CH 3/4 OUTPress UP/DOWN arrow buttons to get Park on screen Park Move to Last SatSearch DSS Park Press Select a or B as appropriateRD-9901 Remote Control Wall Plate Installation RD-9901 Remote Control Wall Plate Telephone CordPositioner Rear Panel Connect to ignition +12 VDC RD-9911 Warning Device Installation/OperationRCA cable Install two AA batteries provided Connect to vehicle groundCable Roof-thru Plate Installation QTYDescription Use Must Perform Must Perform Locating the Satellite Pinnacle RV Digital Satellite System Models RD-9946 Important Safeguards Table of Contents DSS Uplink Signal Programming Uplink Control CentersIntroduction / HOW does Digital Satellite TV WORK? For Programming information call Dish NetworkPress Select a Finding the Satellite Method Using the City MenuSystem Operation Finding the Satellites Select a City Enter ElevationEntry of the previous state Start Search QuitCalculating Press Left arrow button to scroll list to the lastSearching Level = Setting DetectorFine Tuning Azimuth Moving to StartPress Select a if correct satellite was found Fine Tuning ElevationSystem has found a satellite and is fine tuning the signal Correct Satellite Continue SearchPress Select B Enter elevation, Figure Finding the Satellite Method Entering the ElevationPress Select B if correct satellite was not found El Angle =Press Select B Enter Location, Figure Enter Elevation Enter LocationPress Select B Press UP arrow buttonTo decrease latitude by 1o Latitude =Longitude = Press Left arrow buttonLatitude and longitude Putting Antenna in Park Position Move to Last Sat Manual Move Move to Last SatelliteManual Movement Manual Move EditAz3 = El 3 = XXX Press Select a to enter code Edit MenuEdit Search DSS Enter CodeEdit Select Search SatelliteSelect Search Sat Set Motor Positions 101.0Add/Edit Search Satellite Inactive EditQuit Press Select a to enter new satellite as search satellite Winegard* 165.0 QuitWinegard* 165.0 Edit Press Select a to enter satellite into memoryPage Satellite Remote Panel OperationSearch For Satellite Search routine againParking the Antenna Page Pinnacle Positioner Switch was removed 2/16/98 Positioner Controls & IndicatorsProgrammed City Locations Environmental Conditions PowerWinegard Important Safeguards Introduction No Satellite Found Antenna Reflector at Look angleLnbf Coax Center Conductor Return To Defaults Press Select a Set to Defaults. See Figure Test Functions Return to DefaultsSet to Defaults Quit Memory Restored Press Any KeyPositioner Does Not Respond Search Xxxxxx ParkPress Select B Park Name of search satellite Test RD-9901 Remote Control Wallplate Press Select a Test Remote Panel Test LNB Test Remote PanelTest Remote Panel Elevation = Press Select B Test Remote PanelThree times Test Remote Panel Search LED = OnTest Remote Panel Search LED = Off Press UP arrow button twicePress Right arrow button twice Test Remote Panel Park LED = OnTest Remote Panel Park LED = Off Test Remote Panel Search Key PressedTest Remote Panel Park Key Pressed Test LNB Min. is Signal level, max. isAntenna = 0 dB Level = Press Select a Test LNBPositioner Does Not Come On Make sure switch is all Way left or right dependingParking System, Fail Please Check Parking System Fail Please CheckPress either Select a or B When Searching Positioner Displays Search Stopped Winegard Table of Contents Index Part Description QTY Number Antenna Support AssemblyMount Assembly Index Part Description Number Mount Base POSITIONER/ACCESSORIES ANTENNA/FEED Assembly Lnbf CABLE, Part Number For antenna mounts with a serial # of 10111 or higher