Winegard RD-9946 RD-9901 Remote Control Wall Plate Installation, Positioner Rear Panel

Page 14

RD-9901 Remote Control Wall Plate Installation

To install the optional RD-9901, proceed as follows:

1.Connect the 25' telephone cord to the REMOTE CONTROL PANEL plug on rear of positioner. See Figure 16.

NOTE: The RD-9901 will fit into a standard electrical outlet box.

2.Connect other end of telephone cord to plug on side of RD-9901. See Figure 16.

3.Secure RD-9901 with screws provided.

NOTE: Refer to Operation Manual on how to operate the RD-9901.

Positioner Rear Panel

REMOTE

CONTROL

PANEL

RD-9901 Remote Control

Wall Plate

25' Telephone Cord

Figure 16

Rev. 6/98

14

Image 14

Contents Winegard Important Safeguards Not applicable to mount and antennaTable Of Contents Unpacking/InventoryInstallation Requirements Rev 9/98 Installation Satellite System, RD-9946 proceed to stepDo not Caulk Mount Base Ring Page Rev /99 Rev /98 Optional RD-9911 Warning Device Refer to , Page 14 for operation and installationSilver Connecttoignition+12VDCCH 3/4 OUT To Receiver Control Wires To AntennaSensar TV Antenna Receiver PositionerPress Select a or B as appropriate Park Move to Last SatSearch DSS Park Press UP/DOWN arrow buttons to get Park on screenPositioner Rear Panel RD-9901 Remote Control Wall Plate InstallationRD-9901 Remote Control Wall Plate Telephone Cord Connect to vehicle ground RD-9911 Warning Device Installation/OperationRCA cable Install two AA batteries provided Connect to ignition +12 VDCDescription Use Cable Roof-thru Plate InstallationQTY Must Perform Must Perform Locating the Satellite Pinnacle RV Digital Satellite System Models RD-9946 Important Safeguards Table of Contents For Programming information call Dish Network Uplink Signal Programming Uplink Control CentersIntroduction / HOW does Digital Satellite TV WORK? DSSSelect a City Enter Elevation Finding the Satellite Method Using the City MenuSystem Operation Finding the Satellites Press Select aPress Left arrow button to scroll list to the last Start Search QuitCalculating Entry of the previous stateMoving to Start Setting DetectorFine Tuning Azimuth Searching Level =Correct Satellite Continue Search Fine Tuning ElevationSystem has found a satellite and is fine tuning the signal Press Select a if correct satellite was foundFinding the Satellite Method Entering the Elevation Press Select B Enter elevation, FigureEl Angle = Press Select B if correct satellite was not foundPress UP arrow button Enter Elevation Enter LocationPress Select B Press Select B Enter Location, FigurePress Left arrow button Latitude =Longitude = To decrease latitude by 1oLatitude and longitude Putting Antenna in Park Position Move to Last Satellite Move to Last Sat Manual MoveAz3 = El 3 = Manual MovementManual Move Edit XXX Enter Code Edit MenuEdit Search DSS Press Select a to enter code101.0 Select Search SatelliteSelect Search Sat Set Motor Positions EditQuit Add/Edit Search SatelliteInactive Edit Press Select a to enter satellite into memory Winegard* 165.0 QuitWinegard* 165.0 Edit Press Select a to enter new satellite as search satellitePage Search routine again Remote Panel OperationSearch For Satellite SatelliteParking the Antenna Page Pinnacle Positioner Positioner Controls & Indicators Switch was removed 2/16/98Programmed City Locations Power Environmental ConditionsWinegard Important Safeguards Introduction Lnbf No Satellite FoundAntenna Reflector at Look angle Coax Center Conductor Return To Defaults Memory Restored Press Any Key Test Functions Return to DefaultsSet to Defaults Quit Press Select a Set to Defaults. See FigurePress Select B Park Name of search satellite Positioner Does Not RespondSearch Xxxxxx Park Test RD-9901 Remote Control Wallplate Press Select B Test Remote Panel Test LNB Test Remote PanelTest Remote Panel Elevation = Press Select a Test Remote PanelPress UP arrow button twice Test Remote Panel Search LED = OnTest Remote Panel Search LED = Off Three timesTest Remote Panel Search Key Pressed Test Remote Panel Park LED = OnTest Remote Panel Park LED = Off Press Right arrow button twiceTest Remote Panel Park Key Pressed Test LNB Press Select a Test LNB Signal level, max. isAntenna = 0 dB Level = Min. isMake sure switch is all Way left or right depending Positioner Does Not Come OnPress either Select a or B Parking System, Fail Please CheckParking System Fail Please Check When Searching Positioner Displays Search Stopped Winegard Table of Contents Antenna Support Assembly Index Part Description QTY NumberMount Assembly Index Part Description Number Mount Base POSITIONER/ACCESSORIES ANTENNA/FEED Assembly Lnbf CABLE, Part Number For antenna mounts with a serial # of 10111 or higher