Marantz RC3001 manual This jack connects to the supplied AC adapter

Page 11

ENGLISH

RX3001

ON OFF 1 2 3 4

					ID
					1 2
n
1	2	3	4	5	6
x		b
⁄0 c

RX3001

z

v

m

,

.

zDC jack

This jack connects to the supplied AC adapter.

xAntenna

This is a rod antenna for receiving RF signals.

cIR blasters (upper direction)

These transmit IR signals. The Wizz.it 3 editor software can be used to turn transmission of the IR signals on and off.

vIR blasters (front direction)

These transmit IR signals. The Wizz.it 3 editor software can be used to turn the IR signal transmissions on and off.

bIR output jack

This jack connects the supplied IR emitter cable.

nKey holes

These holes are used to mount the remote controller to a wall. For the mounting procedure, see “Mounting the RX3001 to a Wall” on page 8.

mIR output level switches

These DIP switches set the IR transmission level from IR output jacks 1 to 3 and IR output jacks 4 to 6.

,Group ID selector switch

This switch sets the IR output group ID for IR output jacks 1 to 3 and IR output jacks 4 to 6.

.CH selector switch

This switch sets the reception channel. Set to the same channel as the RC3001.

Note:

The CH selector has eight setting positions, but only four channel positions can be set.

⁄0 Power indicator

The red LED turns on when the AC adapter is connected. The red LED ﬂashes when receiving signals.

6

Image 11

Contents Model RC3001 User Guide For US and Canada Deutsch EnglishEspañol FrançaisEspañol EnglishFrançais DeutschNota SUL Riciclaggio Remarque Concernant LE RecyclageRECYCLING-HINWEIS Nota Sobre EL RecicladoFeatures Table of ContentsBefore USE Load the Rechargeable BatteryPack Into the Remote Controller Attach the battery case coverTo the charging terminal next to the USB port Charging the Battery PackRemove the bottom cover of the remote Controller, and connect the AC adapterHome mode and the device modes Remote ControllerCommand Remote controller displayRemote Controller LCD This jack connects the supplied IR emitter cable This is a rod antenna for receiving RF signalsThis jack connects to the supplied AC adapter Mounting Procedure InstallationMounting Location Precautions Mounting Procedure Precautions5mm With Radio Frequency Using the Remote Controller With Infrared RaysUsing the Remote Controller Changing the IR / RF SettingsConnecting to Marantz Equipment Connecting the RX3001 with Other DevicesConnect the supplied AC adapter to the DC jack Connecting to NON-MARANTZ EquipmentConnecting to AN AC Adapter Output 4+5+6 Output 1+2+3 SetupSetting the IR Output Level Setting the ChannelEmitter Output Output signal Setting the Group ID SelectorBasic Operation RC3001 Button SettingsSleep Timer DVD input command for Marantz AV ReceiverEntering the Main Menu Other OperationMain Menu Learning FunctionTo learn This screen changes to Home modePress the button next to the displayed Press the button next to the Timer SET TimerChecking the Settings Operation SettingsPress a button next to the Everyday or Either press the Enter button or wait Operation ON/OFF SettingsClock Clock Setting SYS.SETUPBacklightbacklightillumination Time Setting Message Completed is displayed LCD LCD SettingLCD Timer LCD timer setting This sets the built-in beep sound in the RC3001 Beep Beep Sound SettingMEM Clear Initialization Setting Programmable Codes Status IndicatorReset Specifications MIN105mm 4-3/16ins Up to 100kHz90g 0.2lbs DC9V 800mAIf the equipment becomes heavily soiled Cleaning of Equipment External SurfacesOthers RepairsIs a registered trademark