Marantz RC3001 manual 5mm

Page 13

ENGLISH

2. The positional relationship between the RX3001 key holes and the screw mounting positions are shown in the ﬁgure below.

Notes:

•When mounting the screws to the wall, leave a space between the wall and screw cap as shown in the ﬁgure.

•You can use attached template sheet for the position of screws.

	4.5mm
	(3/16 ins.)
30mm	-3/16ins.)
	(1

4.5mm (3/16 ins.)

30mm

(1-3/16ins.)

Insert the RX3001 key holes onto the two screws mounted to the wall, and then slide downward to secure in place.

After securing the RX3001 to the wall, connect the AC adapter and cables to the RX3001.

Notes:

•Check that the RX3001 is ﬁrmly secured to the wall.

•Insert the AC adapter and IR emitter cable so that they are ﬁrmly connected to the RX3001.

5.When removing the RX3001 from the wall, lift up the RX3001, then pull it towards you.

Image 13

Contents Model RC3001 User Guide For US and Canada Español EnglishFrançais DeutschFrançais EnglishDeutsch EspañolRECYCLING-HINWEIS Remarque Concernant LE RecyclageNota Sobre EL Reciclado Nota SUL RiciclaggioFeatures Table of ContentsPack Into the Remote Controller Load the Rechargeable BatteryAttach the battery case cover Before USERemove the bottom cover of the remote Charging the Battery PackController, and connect the AC adapter To the charging terminal next to the USB portCommand Remote ControllerRemote controller display Home mode and the device modes Remote Controller LCD This jack connects to the supplied AC adapter This is a rod antenna for receiving RF signalsThis jack connects the supplied IR emitter cable Mounting Location Precautions InstallationMounting Procedure Precautions Mounting Procedure5mm Using the Remote Controller Using the Remote Controller With Infrared RaysChanging the IR / RF Settings With Radio FrequencyConnecting to Marantz Equipment Connecting the RX3001 with Other DevicesConnecting to AN AC Adapter Connecting to NON-MARANTZ EquipmentConnect the supplied AC adapter to the DC jack Setting the IR Output Level SetupSetting the Channel Output 4+5+6 Output 1+2+3Emitter Output Output signal Setting the Group ID SelectorSleep Timer RC3001 Button SettingsDVD input command for Marantz AV Receiver Basic OperationMain Menu Other OperationLearning Function Entering the Main MenuPress the button next to the displayed This screen changes to Home modeTo learn Checking the Settings TimerOperation Settings Press the button next to the Timer SETPress a button next to the Everyday or Either press the Enter button or wait Operation ON/OFF SettingsClock Clock Setting SYS.SETUPBacklightbacklightillumination Time Setting LCD Timer LCD timer setting LCD LCD SettingMessage Completed is displayed This sets the built-in beep sound in the RC3001 Beep Beep Sound SettingMEM Clear Initialization Setting Reset Status IndicatorProgrammable Codes Specifications 90g 0.2lbs Up to 100kHzDC9V 800mA MIN105mm 4-3/16insOthers Cleaning of Equipment External SurfacesRepairs If the equipment becomes heavily soiledIs a registered trademark