USING THE REMOTE CONTROLLER
WITH INFRARED RAYS
By default, the remote controller uses infrared (IR) signals to operate devices.
This means that you have to point the IR sending eye of the remote controller towards the devices you are operating.
Operate the device with the remote controller within the range of the illustration below.
60°
Precautions:
•Do not allow direct sunlight, an inverter fluorescent light or other strong source of light to shine onto the player’s infrared signal reception window (remote sensor). Otherwise, the operation of the remote controller may be disabled.
•Bear in mind that operating the remote controller may cause other devices operated by infrared rays to be operated by mistake.
•The remote controller cannot be operated if the space between the remote controller and the device’s remote sensor is obstructed.
•Do not place any objects on top of the remote controller. Doing so may cause one or more buttons to be held down which will cause the batteries to run down.
USING THE REMOTE CONTROLLER |
| ENGLISH |
WITH RADIO FREQUENCY |
| |
|
| |
You can choose to operate devices using Radio |
| |
Frequency (RF) signals instead of IR signals. |
| |
RF signals can, unlike IR signals, go through |
| |
obstacles like furniture or walls. |
| |
The RF signals sent out by the unit are picked up |
| |
by the RX3001 RF Extender. |
| |
The RX3001 translates the RF signals in |
| |
IR signals and sends the IR signals to the |
| |
appropriate devices. |
| |
Therefore, the RX3001 has to be placed near |
| |
the devices you are operating with the RX3001’s |
| |
sending eye pointed to the device or the RX3001 |
| |
is connected to IR Emitters referring to page |
| |
10, 11. |
|
|
The devices will always receive IR signals either |
| |
directly from the RC3001 or from the RX3001. |
| |
Precaution:
This product would not perform normally under a strong electrostatic environment.
CHANGING THE IR / RF SETTINGS
All devices are set up by default to work with IR signals.
To be able to operate one or more devices with RF signals, you have to change the IR/RF settings of the RC3001 by PC editor “Wizz.it3” for those devices.
9