Marantz RC3001 This screen changes to Home mode, Press the button next to the displayed, To learn

Page 21

	ENGLISH	4. This screen changes to HOME mode.
	ENGLISH	Press the button next to the displayed
		Press the button next to the displayed
		device name whose commands you want
		to learn.

Note:

In Home mode, learning cannot be performed with the SOFT button using the procedure shown below. Use the Wizz.it 3 editor to make any changes.

5. After selecting the device name, press the button whose command you want to learn.

6. This enters the learning standby mode. Send the remote controller code that you want to learn.

7. The remote controller has completed learning when “LEARN OK” is displayed on the LCD.

•Pressing the ENTER button enables you to continue learning commands for another button in the same device mode.

•When the learning mode is completed, press the Home button three times to return the LCD to the MAIN MENU.

Notes:

•If learning could not be performed, “LEARN ERROR” is displayed on the LCD. Try performing steps 5 to 6 again.

•When making the learning settings, the “LEARN ERROR” message may occasionally be displayed repeatedly on the LCD. In some cases, this can be due to transmission of a special remote controller signal code. Learning cannot be performed when a special remote controller signal code is used.

•The RC3001 can learn up to a maximum of 1,000 remote controller codes. Once 1,000 codes are programmed for learning, “LEARNFULL” is displayed on the LCD, and learning can no longer be performed.

To perform further learning, use the Wizz.it 3 editor to delete any unneeded learning codes.

16

Image 21

Contents Model RC3001 User Guide For US and Canada Español EnglishFrançais DeutschFrançais EnglishDeutsch EspañolRECYCLING-HINWEIS Remarque Concernant LE RecyclageNota Sobre EL Reciclado Nota SUL RiciclaggioFeatures Table of ContentsPack Into the Remote Controller Load the Rechargeable BatteryAttach the battery case cover Before USERemove the bottom cover of the remote Charging the Battery PackController, and connect the AC adapter To the charging terminal next to the USB portCommand Remote ControllerRemote controller display Home mode and the device modesRemote Controller LCD This is a rod antenna for receiving RF signals This jack connects to the supplied AC adapterThis jack connects the supplied IR emitter cable Mounting Location Precautions InstallationMounting Procedure Precautions Mounting Procedure5mm Using the Remote Controller Using the Remote Controller With Infrared RaysChanging the IR / RF Settings With Radio FrequencyConnecting to Marantz Equipment Connecting the RX3001 with Other DevicesConnecting to NON-MARANTZ Equipment Connecting to AN AC AdapterConnect the supplied AC adapter to the DC jack Setting the IR Output Level SetupSetting the Channel Output 4+5+6 Output 1+2+3Emitter Output Output signal Setting the Group ID SelectorSleep Timer RC3001 Button SettingsDVD input command for Marantz AV Receiver Basic OperationMain Menu Other OperationLearning Function Entering the Main MenuThis screen changes to Home mode Press the button next to the displayedTo learn Checking the Settings TimerOperation Settings Press the button next to the Timer SETPress a button next to the Everyday or Either press the Enter button or wait Operation ON/OFF SettingsClock Clock Setting SYS.SETUPBacklightbacklightillumination Time Setting LCD LCD Setting LCD Timer LCD timer settingMessage Completed is displayed This sets the built-in beep sound in the RC3001 Beep Beep Sound SettingMEM Clear Initialization Setting Status Indicator ResetProgrammable Codes Specifications 90g 0.2lbs Up to 100kHzDC9V 800mA MIN105mm 4-3/16insOthers Cleaning of Equipment External SurfacesRepairs If the equipment becomes heavily soiledIs a registered trademark