Marantz RC3001 manual Setting the Group ID Selector, Emitter Output Output signal

SETTING THE GROUP ID SELECTOR

The RC3001 can use the Wizz.it 3 editor to set the group ID for each device.

If a different ID signal is sent from the remote controller, no control signal is output from the RX3001. Normally, set to “ID1” when not using the group ID function.

	Receiver side
Group ID	Emitter Output
	1	Set ID 1	ID
	2	Set ID 1
1	3	Set ID 1
	4	Set ID 1
	5	Set ID 1
	6	Set ID 1
	Receiver side
Group ID	Emitter Output		1 2
	1	Set ID 1
	2	Set ID 1
2	3	Set ID 1
	4	Set ID 2
	5	Set ID 2
	6	Set ID 2

Output from the Output jack is controlled as shown below based on the remote device ID setting and receiver ID setting.

Remote device ID	Receiver
GROUP ID	GROUP ID SW	Emitter Output	OUTPUT signal
		1	OUTPUT
		2	OUTPUT
1	1	3	OUTPUT
		4	OUTPUT
		5	OUTPUT
		6	OUTPUT
GROUP ID	GROUP ID SW	Emitter Output	OUTPUT signal
		1	NO-OUT
		2	NO-OUT
2	1	3	NO-OUT
		4	NO-OUT
		5	NO-OUT
		6	NO-OUT
GROUP ID	GROUP ID SW	Emitter Output	OUTPUT signal
		1	NO-OUT
		2	NO-OUT
2	2	3	NO-OUT
		4	OUTPUT
		5	OUTPUT
		6	OUTPUT
GROUP ID	GROUP ID SW	Emitter Output	OUTPUT signal
		1	OUTPUT
		2	OUTPUT
1	2	3	OUTPUT
		4	NO-OUT
		5	NO-OUT
		6	NO-OUT

ENGLISH

13