Marantz RC3001 manual LCD LCD Setting, Message Completed is displayed, LCD Timer LCD timer setting

Page 27

ENGLISH

LCD (LCD SETTING)				3. The message “COMPLETED” is displayed

Press the button next to the “LCD” indicator in the				on the LCD to indicate that the display time
SYS.SETUP menu screen in the LCD.				setting is completed.
The LCD setting menu is displayed.

LCD TIMER (LCD timer setting)

This sets the time that the LCD remains on, after a button is pressed on the RC3001.

When there are no operations and the LCD is turned off, this setting enables power consumption to be reduced and the life of the battery pack to be extended.

The default setting is 10 seconds.

1. The LCD setting menu is displayed, and so press the button next to “LCD TIMER” in the LCD display.

2. Press the buttons (right: +, left: -) displayed next to TIME to set the display time. The time can be set in 1-second intervals from 10 to 60 seconds.

To leave the LCD always on, press the button next to the “ALWAYS ON’ indicator. However, please note that this setting will shorten the life of the battery pack.

After deciding the settings, press the ENTER button.

•Either press the ENTER button or wait three seconds for the LCD to automatically return to the SYS.SETUP menu.

•Pressing the Home button returns the LCD to the MAIN MENU.

Note:

If the LCD is turned off by the LCD timer, pressing any of the buttons on the remote controller will turn it on again. When the LCD is turned on, the pressed command is not activated.

To execute a command operation, press the button while the LCD is on.

22

Image 27

Contents Model RC3001 User Guide For US and Canada Deutsch EnglishEspañol FrançaisEspañol EnglishFrançais DeutschNota SUL Riciclaggio Remarque Concernant LE RecyclageRECYCLING-HINWEIS Nota Sobre EL RecicladoFeatures Table of ContentsBefore USE Load the Rechargeable BatteryPack Into the Remote Controller Attach the battery case coverTo the charging terminal next to the USB port Charging the Battery PackRemove the bottom cover of the remote Controller, and connect the AC adapterHome mode and the device modes Remote ControllerCommand Remote controller displayRemote Controller LCD This is a rod antenna for receiving RF signals This jack connects to the supplied AC adapterThis jack connects the supplied IR emitter cable Mounting Procedure InstallationMounting Location Precautions Mounting Procedure Precautions5mm With Radio Frequency Using the Remote Controller With Infrared RaysUsing the Remote Controller Changing the IR / RF SettingsConnecting to Marantz Equipment Connecting the RX3001 with Other DevicesConnecting to NON-MARANTZ Equipment Connecting to AN AC AdapterConnect the supplied AC adapter to the DC jack Output 4+5+6 Output 1+2+3 SetupSetting the IR Output Level Setting the ChannelEmitter Output Output signal Setting the Group ID SelectorBasic Operation RC3001 Button SettingsSleep Timer DVD input command for Marantz AV ReceiverEntering the Main Menu Other OperationMain Menu Learning FunctionThis screen changes to Home mode Press the button next to the displayedTo learn Press the button next to the Timer SET TimerChecking the Settings Operation SettingsPress a button next to the Everyday or Either press the Enter button or wait Operation ON/OFF SettingsClock Clock Setting SYS.SETUPBacklightbacklightillumination Time Setting LCD LCD Setting LCD Timer LCD timer settingMessage Completed is displayed This sets the built-in beep sound in the RC3001 Beep Beep Sound SettingMEM Clear Initialization Setting Status Indicator ResetProgrammable Codes Specifications MIN105mm 4-3/16ins Up to 100kHz90g 0.2lbs DC9V 800mAIf the equipment becomes heavily soiled Cleaning of Equipment External SurfacesOthers RepairsIs a registered trademark