Marantz RC3001 manual Status Indicator, Reset, Programmable Codes

Page 30

4. STATUS INDICATOR

This displays the settings made in the MAIN MENU and the status of the remote device.

CHECKING THE STATUS

1. Display the MAIN MENU on the LCD of the RC3001, then press the button next to the “STATUS” indicator.

2. Pressing the ENTER button cycles through the statuses of each of the items below.

•Remaining learning memory

•Remaining macro steps

•LCD timer setting

•Backlight timer setting

•Beep setting

•Firmware version

•Current clock time

Either press the ENTER button or wait three seconds so that the LCD returns to the MAIN MENU.

5. RESET

If the RC3001 is not operating properly, use the procedure below to perform a reset (restart). Performing a reset does not erase the settings in the RC3001.

1. Remove the battery case cover.

2. Use a paper clip or other object to press the reset button in the reset hole as shown in the ﬁgure below to reset the RC3001.

ENGLISH

Note:

Perform the reset with the battery pack loaded.

6. PROGRAMMABLE CODES

NUMBER OF PROGRAMMABLE CODES

This remote control has Flash memory 4M bit (512KB) that enables it to program remote control signals include the learned codes for up to 8000 codes.

This number is for Marantz remote control codes.

The actual number of codes may be less than 8000 depending on the type of the programmed remote control signals.

PROGRAMMABLE CODES

This remote control may be unable to learn the codes for some AV equipment due to the code types, system, or other differences.

25

Image 30

Contents Model RC3001 User Guide For US and Canada Français EnglishEspañol DeutschDeutsch EnglishFrançais EspañolNota Sobre EL Reciclado Remarque Concernant LE RecyclageRECYCLING-HINWEIS Nota SUL RiciclaggioTable of Contents FeaturesAttach the battery case cover Load the Rechargeable BatteryPack Into the Remote Controller Before USEController, and connect the AC adapter Charging the Battery PackRemove the bottom cover of the remote To the charging terminal next to the USB portRemote controller display Remote ControllerCommand Home mode and the device modesRemote Controller LCD This is a rod antenna for receiving RF signals This jack connects to the supplied AC adapterThis jack connects the supplied IR emitter cable Mounting Procedure Precautions InstallationMounting Location Precautions Mounting Procedure5mm Changing the IR / RF Settings Using the Remote Controller With Infrared RaysUsing the Remote Controller With Radio FrequencyConnecting the RX3001 with Other Devices Connecting to Marantz EquipmentConnecting to NON-MARANTZ Equipment Connecting to AN AC AdapterConnect the supplied AC adapter to the DC jack Setting the Channel SetupSetting the IR Output Level Output 4+5+6 Output 1+2+3Setting the Group ID Selector Emitter Output Output signalDVD input command for Marantz AV Receiver RC3001 Button SettingsSleep Timer Basic OperationLearning Function Other OperationMain Menu Entering the Main MenuThis screen changes to Home mode Press the button next to the displayedTo learn Operation Settings TimerChecking the Settings Press the button next to the Timer SETPress a button next to the Everyday or Operation ON/OFF Settings Either press the Enter button or waitSYS.SETUP Clock Clock SettingBacklightbacklightillumination Time Setting LCD LCD Setting LCD Timer LCD timer settingMessage Completed is displayed Beep Beep Sound Setting This sets the built-in beep sound in the RC3001MEM Clear Initialization Setting Status Indicator ResetProgrammable Codes Specifications DC9V 800mA Up to 100kHz90g 0.2lbs MIN105mm 4-3/16insRepairs Cleaning of Equipment External SurfacesOthers If the equipment becomes heavily soiledIs a registered trademark