ENGLISH
SETUP
SETTING THE IR OUTPUT LEVEL
The DIP switches at the bottom of the RX3001 can be used to set the IR output levels from IR output jacks 1 to 3 and IR output jacks 4 to 6.
Note:
The default setting is high output (LEVEL 4), and so when the IR emitter is affixed to a device, the output level can be so high that remote commands cannot be controlled properly.
Be sure to set the IR output level according to the status of the connected device.
ON OFF 1 2 3 4
| 2 1 |
DI |
|
| 4 |
| 3 |
FFO | 2 |
1 | |
| NO |
OUT6
OUT5
OUT4
6 5 4
OUT3 OUT2 OUT1
3 2 1
LEVEL | OUTPUT 4+5+6 | OUTPUT 1+2+3 | |||
|
|
|
| ||
SW 1 | SW 2 | SW 3 | SW 4 | ||
| |||||
|
|
|
|
| |
1 | OFF | OFF | OFF | OFF | |
|
|
|
|
| |
2 | OFF | ON | OFF | ON | |
|
|
|
|
| |
3 | ON | OFF | ON | OFF | |
|
|
|
|
| |
4 | ON | ON | ON | ON | |
|
|
|
|
|
SETTING THE CHANNEL
Use the CH selector knob to set to the same channel as the RC3001.
ON OFF 1 2 3 4
ID
1 2
CH selector knob
Notes:
•When setting the channel with the CH selector, the available channels are CH1 to CH4 with two setting positions for each channel.
CH1
CH2
CH3
CH4
•The RC3001 default channel is channel 1.
•To change the channel of the remote controller, change the channel setting in the Wizz.it 3 editor.
12