Pioneer DVR-RT501-S operating instructions Operating Environment, For USE in the United, Kingdom

S002_En

D3-4-2-2-1a_A_En

D3-4-2-1-7b_A_En

K041_En

D3-4-2-1-7c_A_En

D3-4-2-1-7a_A_En

WARNING

To prevent a fire hazard, do not place any naked flame sources (such as a lighted candle) on the equipment.

Operating Environment

Operating environment temperature and humidity:

+5 ￿C – +35 ￿C (+41 ￿F – +95 ￿F); less than 80 %RH (cooling vents not blocked)

Do not install this unit in a poorly ventilated area, or in locations exposed to high humidity or direct sunlight (or strong artificial light)

VENTILATION CAUTION

When installing this unit, make sure to leave space around the unit for ventilation to improve heat radiation (at least 10 cm at top, 10 cm at rear, and 10 cm at each side).

WARNING

Slots and openings in the cabinet are provided for ventilation to ensure reliable operation of the product, and to protect it from overheating. To prevent fire hazard, the openings should never be blocked or covered with items (such as newspapers, table-cloths, curtains) or by operating the equipment on thick carpet or a bed.

If the AC plug of this unit does not match the AC outlet you want to use, the plug must be removed and appropriate one fitted. Replacement and mounting of an AC plug on the power supply cord of this unit should be performed only by qualified service personnel. If connected to an AC outlet, the cut-off plug can cause severe electrical shock. Make sure it is properly disposed of after removal.

The equipment should be disconnected by removing the mains plug from the wall socket when not left unused for a long period of time (for example, when on vacation).

This product incorporates copyright protection technology that is protected by method claims of certain U.S. patents and other intellectual property rights owned by Macrovision Corporation and other rights owners. Use of this copyright protection technology must be authorized by Macrovision Corporation, and is intended for home and other limited viewing uses only unless otherwise authorized by Macrovision Corporation. Reverse engineering or disassembly is prohibited.

This product is for general household purposes. Any failure due to use for other than household purposes (such as long- term use for business purposes in a restaurant or use in a car or ship) and which requires repair will be charged for even during the warranty period.

If you want to dispose this product, do not mix it with general household waste. There is a separate collection system for used electronic products in accordance with legislation that requires proper treatment, recovery and recycling.

Private households in the 25 member states of the EU, in Switzerland and Norway may return their used electronic products free of charge to designated collection facilities or to a retailer (if you purchase a similar new one).

For countries not mentioned above, please contact your local authorities for the correct method of disposal.

By doing so you will ensure that your disposed product undergoes the necessary treatment, recovery and recycling and thus prevent potential negative effects on the environment and human health.

POWER-CORD CAUTION

Handle the power cord by the plug. Do not pull out the plug by tugging the cord and never touch the power cord when your hands are wet as this could cause a short circuit or electric shock. Do not place the unit, a piece of furniture, etc., on the power cord, or pinch the cord. Never make a knot in the cord or tie it with other cords. The power cords should be routed such that they are not likely to be stepped on. A damaged power cord can cause a fire or give you an electrical shock. Check the power cord once in a while. When you find it damaged, ask your nearest PIONEER authorized service center or your dealer for a replacement.

Replacement and mounting of an AC plug on the power supply cord of this unit should be performed only by qualified service personnel.

IMPORTANT		The cut-off plug should be disposed of and must	Do not connect either wire to the earth terminal of a
		not be inserted into any 13 amp socket as this can	three pin plug.
		result in electric shock. The plug or adaptor or the	NOTE
FOR USE IN THE UNITED		distribution panel should be provided with 5 A fuse.
		As the colours of the wires in the mains lead of this	After replacing or changing a fuse, the fuse cover in
KINGDOM
		appliance may not correspond with coloured	the plug must be replaced with a fuse cover which
The wires in this mains lead are coloured in		markings identifying the terminals in your plug,	corresponds to the colour of the insert in the base
accordance with the following code:		proceed as follows ;	of the plug or the word that is embossed on the
Blue	: Neutral	The wire which is coloured blue must be connected	base of the plug, and the appliance must not be
Brown	: Live	to the terminal which is marked with the letter N or	used without a fuse cover. If lost replacement fuse
If the plug provided is unsuitable for your socket		coloured black.	covers can be obtained from your dealer.
outlets, the plug must be cut off and a suitable plug		The wire which is coloured brown must be	Only 5 A fuses approved by B.S.I or A.S.T.A to
fitted.		connected to the terminal which is marked with the	B.S.1362 should be used.
		letter L or coloured red.	D3-4-2-1-2-2_En

2H30301B_En_01_03 3 8/4/05, 19:18