PREPARATION FOR USE
ANTENNA/CABLE CONNECTIONS
Plug the incoming cable into the ANT. jack on the rear of the unit.
If your cable service supplies you with a converter box or if you use a satellite system, connect the box with this unit as shown below.
Cable OR Antenna
TV signal
Incoming cable from home Antenna / Cable Company (No Cable Box)
OR
Cable Box or Satellite Box*
OUT
IN
Incoming cable from Cable Company or Satellite Antenna
ANT.
Rear of the unit
ANT.
*NOTE
(DO NOT DISCONNECT FROM BOX) Some cable TV systems use scrambled signals and require a special converter to receive these channels. Consult your local cable company.
NOTE:
Before plugging the antenna into the ANT. jack of the unit, check that the pin is not bent. If it is bent, straighten the pin as illustrated, then plug the pin into the ANT. jack of the unit.
Bent pin
Cable Plug
(Needs to be straightened) | (Straight pin) |
For your safety and to avoid damages to the unit, unplug the antenna cable from the ANT. jack before moving the unit.
6
EN