Panasonic AJ-D230HP Pause/still recording back-space assemble recording, Playback, Cue and Review

Page 15

Operation

Pause/still recording (back-space assemble recording)

1 Press the PAUSE/STILL button while the cassette tape is playing.

If the “AUTO BACK” set-up menu item has been set to ON, the tape will be rewound for 1 or 2 seconds starting at the position where the PAUSE/STILL button was pressed.

(See page 25)

2

3

Press the REC button to set the unit to the REC PAUSE mode.

The monitor display now switches to the E-E screen.

Press the PAUSE/STILL button to start the recording.

The tape runs to the position where the PAUSE/STILL button was pressed in step 1, and the recording is started.

<Note>

The E-E screen now appears.

Playback

1

2

Insert the cassette tape.

Press the PLAY button.

Normal playback is now commenced.

3	To stop playback, press the STOP button.
	The VTR is now set to the stop mode.

<Note>

During playback, check that the SERVO lamp is lighted. If the lamp is off or flashing, the images played back will appear disturbed.

Cue and Review

Keep pressing the FF or REW button during playback.

While the button is held down, the tape is cued or reviewed at approximately 10× normal tape speed.

Normal playback is restored when the button is released.

The cue track sound is output during cue or review if the “SEARCH CUE” set-up menu item has been set to ON. (See page 30)

Still-picture playback

Press the PAUSE/STILL button during playback.

When it is pressed again, normal playback is restored.

No sound is heard during still-picture playback.

15

Image 15

Contents Operating Instructions FCC Note Table of Contents RS-232C Interface Introduction FeaturesControls and Their Functions Front PanelCounter display area Cassette slot Power switchLOCAL/MENU/REMOTE switch Input Select switchReset button Volume controlVolume recording level control Remote control connectorConnector section Sync in connector AC in connectorSignal GND terminal Handle Video in connectorUse of Panasonic consumer DV cassette tape is recommended TapesType DescriptionInsert the cassette tape Switching on the power and inserting the cassetteSwitch on the power OperationPrecautions for setting the still timer Stop modeRecording Still-picture playback Pause/still recording back-space assemble recordingPlayback Cue and ReviewUse the Audio OUT Select button to select the desired sound Mode Audio OUT connectors Display tubeFrame advance Sound selectionSet the VTR to the menu mode Repeat playbackMenu screen Set the VTR to the local mode Setting Description of operationOFF MEM Stop Repeat Continue Time Code and User’s Bit Time codeUser’s bit Setting the user’s bit Setting the time codeDisplay changes as shown below Time code and user’s bit playbackDisplay position Operating modeSuperimposed Display Screens Characters displayedUpon completion of the setting, press the SET REC button Set-up Default SettingsChanging a setting SettingSetting Set-up MenusBasic menu Operation menu Description of settingsInterface menu Type Format SEL settingTape Protect menu Memory Mode menuTime Code menu Setting Description of settingsLOW-RF Video menuColor MuteAudio menu RS-232C InterfaceCommunication parameters Interface specificationsExample of wiring connections Pin No SignalCommunication system Asynchronous, full duplex Baud rate External interface specificationsSending format from personal computer to VTR Data format Receiving format from VTR to personal computerSTX QOP ETX ACK STX OEJ ETX STX QCD ETX ACK STX CD Send Description of operation Command list Key commandsStatus command VTR operation mode CodeCounter sense command Standby OFF commandsDeck ID command Description of error Error NoCondensation Video Head CleaningMaintenance Set the VTR to the remote modeLine IN/line OUT Input connectorsOutput connectors Digital videoService Centers