Panasonic AJ-D230HP operating instructions Stop mode, Precautions for setting the still timer

Page 13

Operation

Stop mode

1 The unit is set to the stop mode when the STOP button is pressed.

The STOP lamp lights and the tape stops traveling.

In order to protect the tape, the unit is set to the tape protection mode after the period of time set in the “STILL TIMER” set-up menu item has elapsed. (See page 27) When the STOP, REW, FF or PLAY button is pressed, the unit is set to the corresponding mode.

<Precautions for setting the still timer>

When the same part of the same tape is used repeatedly, the cumulative standby time in the same place increases.

In order to protect the tape, set the standby time for the same place on the same tape to as short a duration as possible.

1

13

Image 13
Contents Operating Instructions FCC Note Table of Contents RS-232C Interface Introduction FeaturesFront Panel Controls and Their FunctionsCounter display area LOCAL/MENU/REMOTE switch Power switchInput Select switch Cassette slotVolume recording level control Volume controlRemote control connector Reset buttonConnector section Signal GND terminal AC in connectorHandle Video in connector Sync in connectorType TapesDescription Use of Panasonic consumer DV cassette tape is recommendedSwitch on the power Switching on the power and inserting the cassetteOperation Insert the cassette tapePrecautions for setting the still timer Stop modeRecording Playback Pause/still recording back-space assemble recordingCue and Review Still-picture playbackFrame advance Mode Audio OUT connectors Display tubeSound selection Use the Audio OUT Select button to select the desired soundRepeat playback Set the VTR to the menu modeMenu screen Setting Description of operation Set the VTR to the local modeOFF MEM Stop Repeat Continue Time code Time Code and User’s BitUser’s bit Setting the user’s bit Setting the time codeDisplay changes as shown below Time code and user’s bit playbackSuperimposed Display Screens Operating modeCharacters displayed Display positionChanging a setting Set-up Default SettingsSetting Upon completion of the setting, press the SET REC buttonSet-up Menus SettingBasic menu Operation menu Description of settingsInterface menu Type Format SEL settingTape Protect menu Memory Mode menuTime Code menu Setting Description of settingsColor Video menuMute LOW-RFAudio menu RS-232C InterfaceExample of wiring connections Interface specificationsPin No Signal Communication parametersSending format from personal computer to VTR Data format External interface specificationsReceiving format from VTR to personal computer Communication system Asynchronous, full duplex Baud rateSTX QOP ETX ACK STX OEJ ETX STX QCD ETX ACK STX CD Status command Command list Key commandsVTR operation mode Code Send Description of operationStandby OFF commands Counter sense commandDeck ID command Description of error Error NoMaintenance Video Head CleaningSet the VTR to the remote mode CondensationOutput connectors Input connectorsDigital video Line IN/line OUTService Centers