Panasonic AJ-D230HP Superimposed Display Screens, Characters displayed, Display position

Page 22

Superimposed Display Screens

When the MONITOR OUT connector has been connected to the TV monitor, the abbreviations corresponding to the control signal, time code, etc. are displayed on the TV monitor.

CTL (control signal)

TCR (time code playback value)

AbbreviationUBR (user’s bit playback value)

REMAIN (remaining tape length)

TV monitor

Characters displayed

The background of the characters superimposed onto the display can be changed using the “CHARA TYPE” set-up menu item. (See page 24)

TV monitor

TV monitor

Display position

The position where the characters are superimposed onto the display can be changed using the “CHARA H-POS” and “CHARA V-POS” set-up menu items. (See page 24)

 

 

<Note>

 

 

 

The counter display is made to appear

 

 

for as long as the MODE button is held

 

 

down, enabling the settings to be

 

 

checked.

Even while the MODE

 

 

button is held down, the DATA+ and

 

 

DATA– buttons can be used to

 

 

perform settings while the actual

TV monitor

TV monitor

situation is checked.

 

 

Operating mode

When “T, STA” has been selected for the “DISPLAY SEL” set-up menu item, the VTR’s operating mode is also displayed. (See page 24)

VTR operation mode

TV monitor

22

Image 22
Contents Operating Instructions FCC Note Table of Contents RS-232C Interface Features IntroductionFront Panel Controls and Their FunctionsCounter display area Input Select switch Power switchLOCAL/MENU/REMOTE switch Cassette slotRemote control connector Volume controlVolume recording level control Reset buttonConnector section Handle Video in connector AC in connectorSignal GND terminal Sync in connectorDescription TapesType Use of Panasonic consumer DV cassette tape is recommendedOperation Switching on the power and inserting the cassetteSwitch on the power Insert the cassette tapeStop mode Precautions for setting the still timerRecording Cue and Review Pause/still recording back-space assemble recordingPlayback Still-picture playbackSound selection Mode Audio OUT connectors Display tubeFrame advance Use the Audio OUT Select button to select the desired soundRepeat playback Set the VTR to the menu modeMenu screen Setting Description of operation Set the VTR to the local modeOFF MEM Stop Repeat Continue Time code Time Code and User’s BitUser’s bit Setting the time code Setting the user’s bitTime code and user’s bit playback Display changes as shown belowCharacters displayed Operating modeSuperimposed Display Screens Display positionSetting Set-up Default SettingsChanging a setting Upon completion of the setting, press the SET REC buttonSet-up Menus SettingBasic menu Description of settings Operation menuType Format SEL setting Interface menuMemory Mode menu Tape Protect menuSetting Description of settings Time Code menuMute Video menuColor LOW-RFRS-232C Interface Audio menuPin No Signal Interface specificationsExample of wiring connections Communication parametersReceiving format from VTR to personal computer External interface specificationsSending format from personal computer to VTR Data format Communication system Asynchronous, full duplex Baud rateSTX QOP ETX ACK STX OEJ ETX STX QCD ETX ACK STX CD VTR operation mode Code Command list Key commandsStatus command Send Description of operationStandby OFF commands Counter sense commandDeck ID command Error No Description of errorSet the VTR to the remote mode Video Head CleaningMaintenance CondensationDigital video Input connectorsOutput connectors Line IN/line OUTService Centers