Panasonic AJ-D230HP operating instructions Set-up Default Settings, Changing a setting

Page 23

Set-up (Default Settings)

The VTR’s major settings are performed by making selections using a menu system. The set-up menus appear on the TV monitor when it is connected to the MONITOR OUT connector.

Changing a setting

1	Set the VTR to the menu mode.
	(Set the LOCAL/MENU/REMOTE switch to the MENU position.)
2	Select the item to be set using the UP (FF) and DOWN (STOP) buttons. The cursor
	on the menu screen moves and selects the item.
	The cursor ( ) is moved to the previous set-up menu item number using the DOWN
	button and the next set-up menu item number using the UP button.
3	Press the DATA+ (PAUSE/STILL) button or DATA– (PLAY) button to change the
	setting.
4	Upon completion of the setting, press the SET (REC) button.
	The change is now stored in the memory.

To return from the new setting to the original setting, set the LOCAL/MENU/REMOTE switch to the LOCAL or REMOTE position instead of pressing the SET (REC) button.

5 Set the LOCAL/MENU/REMOTE switch to the LOCAL or REMOTE position.

<Note>

To return the setup selections to the factory (default) settings, press the RESET button while the SETUP. menu is shown. The following message is then displayed.

SETUP-MENU INIT. SET

OK? (PUSH REC KEY)

The default settings will be restored when the REC button is pressed.

1

2 3 4

23

Image 23

Contents Operating Instructions FCC Note Table of Contents RS-232C Interface Introduction FeaturesCounter display area Controls and Their FunctionsFront Panel Cassette slot Power switchLOCAL/MENU/REMOTE switch Input Select switchReset button Volume controlVolume recording level control Remote control connectorConnector section Sync in connector AC in connectorSignal GND terminal Handle Video in connectorUse of Panasonic consumer DV cassette tape is recommended TapesType DescriptionInsert the cassette tape Switching on the power and inserting the cassetteSwitch on the power OperationPrecautions for setting the still timer Stop modeRecording Still-picture playback Pause/still recording back-space assemble recordingPlayback Cue and ReviewUse the Audio OUT Select button to select the desired sound Mode Audio OUT connectors Display tubeFrame advance Sound selectionMenu screen Set the VTR to the menu modeRepeat playback OFF MEM Stop Repeat Continue Set the VTR to the local modeSetting Description of operation User’s bit Time Code and User’s BitTime code Setting the user’s bit Setting the time codeDisplay changes as shown below Time code and user’s bit playbackDisplay position Operating modeSuperimposed Display Screens Characters displayedUpon completion of the setting, press the SET REC button Set-up Default SettingsChanging a setting SettingBasic menu SettingSet-up Menus Operation menu Description of settingsInterface menu Type Format SEL settingTape Protect menu Memory Mode menuTime Code menu Setting Description of settingsLOW-RF Video menuColor MuteAudio menu RS-232C InterfaceCommunication parameters Interface specificationsExample of wiring connections Pin No SignalCommunication system Asynchronous, full duplex Baud rate External interface specificationsSending format from personal computer to VTR Data format Receiving format from VTR to personal computerSTX QOP ETX ACK STX OEJ ETX STX QCD ETX ACK STX CD Send Description of operation Command list Key commandsStatus command VTR operation mode CodeDeck ID command Counter sense commandStandby OFF commands Description of error Error NoCondensation Video Head CleaningMaintenance Set the VTR to the remote modeLine IN/line OUT Input connectorsOutput connectors Digital videoService Centers