Panasonic AJ-D230HP operating instructions Recording

Page 14

Operation

Recording

1

Set the accidental erasure prevention tab on the cassette tape to “recording,” and

 

insert the tape.

2

3

4

Press the STOP button to set the unit to the stop mode.

Check that the REC INH lamp is off.

Selecting the video and audio input signals and adjusting the audio signal level

4-1

4-2

Selecting the video and audio input signals

1 Connect the signals which are to be recorded.

2 Select the input signals using the INPUT SELECT switch on the front panel.

Adjusting the audio signal level

1 Adjust the audio input signal level.

The audio signals are recorded at the appropriate level when the level controls are set to the center click-stop position.

5

Press the PLAY button while holding down the REC button.

 

The REC and PLAY lamps light, and recording is commenced.

6

To stop recording, press the STOP button.

 

Recording is now ended, and the unit is set to the stop mode.

<Notes>

A recording cannot be made properly on a tape on which the recording protection signal has been recorded as an input signal.

During recording, check that the SERVO lamp is lighted. If the lamp is flashing or off, the images played back will be disturbed.

14

Image 14
Contents Operating Instructions FCC Note Table of Contents RS-232C Interface Features IntroductionCounter display area Controls and Their FunctionsFront Panel Input Select switch Power switchLOCAL/MENU/REMOTE switch Cassette slotRemote control connector Volume controlVolume recording level control Reset buttonConnector section Handle Video in connector AC in connectorSignal GND terminal Sync in connectorDescription TapesType Use of Panasonic consumer DV cassette tape is recommendedOperation Switching on the power and inserting the cassetteSwitch on the power Insert the cassette tapeStop mode Precautions for setting the still timerRecording Cue and Review Pause/still recording back-space assemble recordingPlayback Still-picture playbackSound selection Mode Audio OUT connectors Display tubeFrame advance Use the Audio OUT Select button to select the desired soundMenu screen Set the VTR to the menu modeRepeat playback OFF MEM Stop Repeat Continue Set the VTR to the local modeSetting Description of operation User’s bit Time Code and User’s BitTime code Setting the time code Setting the user’s bitTime code and user’s bit playback Display changes as shown belowCharacters displayed Operating modeSuperimposed Display Screens Display positionSetting Set-up Default SettingsChanging a setting Upon completion of the setting, press the SET REC buttonBasic menu SettingSet-up Menus Description of settings Operation menuType Format SEL setting Interface menuMemory Mode menu Tape Protect menuSetting Description of settings Time Code menuMute Video menuColor LOW-RFRS-232C Interface Audio menuPin No Signal Interface specificationsExample of wiring connections Communication parametersReceiving format from VTR to personal computer External interface specificationsSending format from personal computer to VTR Data format Communication system Asynchronous, full duplex Baud rateSTX QOP ETX ACK STX OEJ ETX STX QCD ETX ACK STX CD VTR operation mode Code Command list Key commandsStatus command Send Description of operationDeck ID command Counter sense commandStandby OFF commands Error No Description of errorSet the VTR to the remote mode Video Head CleaningMaintenance CondensationDigital video Input connectorsOutput connectors Line IN/line OUTService Centers