Panasonic AJ-D230HP Time code and user’s bit playback, Display changes as shown below

Page 21

Time Code and User’s Bit

Time code and user’s bit playback

1

2

Set the VTR to the STOP mode.

Set to TC or UB using the COUNTER button.

TC : The time code is displayed.

UB : The user’s bit is displayed.

When the time code can no longer be read, interpolation is provided by the control signal if the COUNTER button is set to the CTL position.

3 Press the PLAY button.

Playback is commenced, and the time code appears on the display. When the “DISPLAY SEL” set-up menu item is set to “TIME” or “T, STA,” the time code value is superimposed onto the video signals which are output from the MONITOR OUT connector.

(See page 24)

<Notes>

The colon between the seconds and frames changes to a period while the drop frame time code is being read.

If the time code signal is missing, interpolation is automatically provided by the CTL signal.

The display changes as shown below.

T R	0 0 : 0 7 : 0 4 : 2 4

The colon (” : ”) between the seconds and frames changes to a period (" . “) in the drop frame mode.

appears when the time code signal is missing (superimposed display only).

21

Image 21

Contents Operating Instructions FCC Note Table of Contents RS-232C Interface Introduction FeaturesControls and Their Functions Front PanelCounter display area LOCAL/MENU/REMOTE switch Power switchInput Select switch Cassette slotVolume recording level control Volume controlRemote control connector Reset buttonConnector section Signal GND terminal AC in connectorHandle Video in connector Sync in connectorType TapesDescription Use of Panasonic consumer DV cassette tape is recommendedSwitch on the power Switching on the power and inserting the cassetteOperation Insert the cassette tapePrecautions for setting the still timer Stop modeRecording Playback Pause/still recording back-space assemble recordingCue and Review Still-picture playbackFrame advance Mode Audio OUT connectors Display tubeSound selection Use the Audio OUT Select button to select the desired soundSet the VTR to the menu mode Repeat playbackMenu screen Set the VTR to the local mode Setting Description of operationOFF MEM Stop Repeat Continue Time Code and User’s Bit Time codeUser’s bit Setting the user’s bit Setting the time codeDisplay changes as shown below Time code and user’s bit playbackSuperimposed Display Screens Operating modeCharacters displayed Display positionChanging a setting Set-up Default SettingsSetting Upon completion of the setting, press the SET REC buttonSetting Set-up MenusBasic menu Operation menu Description of settingsInterface menu Type Format SEL settingTape Protect menu Memory Mode menuTime Code menu Setting Description of settingsColor Video menuMute LOW-RFAudio menu RS-232C InterfaceExample of wiring connections Interface specificationsPin No Signal Communication parametersSending format from personal computer to VTR Data format External interface specificationsReceiving format from VTR to personal computer Communication system Asynchronous, full duplex Baud rateSTX QOP ETX ACK STX OEJ ETX STX QCD ETX ACK STX CD Status command Command list Key commandsVTR operation mode Code Send Description of operationCounter sense command Standby OFF commandsDeck ID command Description of error Error NoMaintenance Video Head CleaningSet the VTR to the remote mode CondensationOutput connectors Input connectorsDigital video Line IN/line OUTService Centers