JVC HR-S8600EK setup guide Storing Channels Manually, Input Channel, Enter NEW Channel Information

[5°] : SELECT

[°°] : CURSOR +=

: OK [MENU] : EXIT

The blueback screen and the programme currently being broadcast by the selected channel appear alternately for 8 seconds each.

PR CH ID FINE DECODER

06 CH21 – – – – +/– OFF

56SUBSIDIARYSETTINGS(cont.)

1– –:– –

	2
	1	2	3
NUMBER	4	5	6

7 8 9

0

1

2MENU

3

4

4

3 OK

	SELECT BAND
	Press %Þ to change the
	band between CH (regular)
	and CC (cable), then	PR	CH ID	FINE DECODER
4 press #.		06	CH01 – – – –	+/– OFF
		[5°] : SELECT
		[°°] : CURSOR +=
			: OK
		[MENU] : EXIT

The blueback screen and the programme currently being broadcast by the selected channel appear alternately for 8 seconds each.

INPUT CHANNEL

5 Press the NUMBER keys to input the channel number you want to store.

●To input the registered station name (ID – ☞

pg. 59), press #until "– – – –" (ID setting) begins blinking, then press %Þ.

￿

Storing Channels Manually

To store channels that were not stored during Auto Set Up (☞ pg. 8), Preset Download (☞ pg. 9) or Auto Channel Set (☞ pg. 54).

1	ACCESS MAIN MENU
	Press MENU.
	ACCESS CONFIRMATION
2	SCREEN
	Press %Þ to move the highlight bar (pointer) to
	“MANUAL CH SET”, then press OK or #. The Confir-
	mation screen appears.
3	SELECT POSITION
	Press %Þ @ #until an	(Ex.) To store in position 6.
	open position in which			PR	CH	ID	PR CH	ID
	you want to store a
		01			26	BBC1	08	– – – –
	channel begins blinking,	02			33	BBC2	09	– – – –
	then press OK. The Manual	03			23	ITV	10	– – – –
		04			30	CH4	11	– – – –
	Channel Set screen	05			37	CH5	12	– – – –
	appears.		06			– – – –	13	– – – –
		07				– – – –	14	– – – –
				[5°55]
				=		: EDIT
				= [X] : DELETE
				[MENU] : EXIT
	The blueback screen and the
	programme currently being
	broadcast by the selected channel
	appear alternately for 8 seconds
	each.

● For fine tuning adjustment, press # until "+/–" begins blinking, then press %Þ. While tuning, "+" or "–" appears.

●When "AV2 SELECT" is set to "AV2", the "DECODER" setting cannot be changed (☞ pg. 40).

ENTER NEW CHANNEL

INFORMATION

6 Press OK and the Confirmation screen appears.

●Repeat steps 3 through 6 as necessary.

CLOSE CONFIRMATION SCREEN

7 Press MENU.

●To change positions, see "Change Station Preset Position" (☞ pg. 57).

●If you wish to set station names other than the ones registered in your recorder, ☞ "Set Stations (B)" on page 58.

ATTENTION

Guide Program numbers are not set when channels are stored manually. If an attempt is made at timer program- ming with VIDEO Plus+ in this state, the “GUIDE PROG SET” screen appears; set the Guide Program numbers on this screen. ☞ “ATTENTION – Regarding Guide Program Number Set” on page 17.

Or perform “Guide Program Number Set” (☞ pg. 62).