Basic Operations | Lexicon, Inc. |
A Quick Guide to Operation, Continued
(4) Editing a Program or Register
Once a Program or Register is loaded, you can edit it to get exactly the effect you want. The simplest way to do this is by changing the settings of the parameters assigned to the faders and joystick on the
For parameters assigned to faders:
• Touch the fader you want to change. When you |
do, that parameter and its setting will be |
highlighted in yellow on the Scribble Strip and will |
appear, in larger lettering, on the Action Display. |
Move the fader to get the desired setting. |
• If you can’t move the fader in small enough |
future use, press the STORE key. The STORE key will blink to remind you that the store operation is pending.
• If you’ve been editing a
Figure
JOYSTICK STATUS Display
increments to get the precise setting you need, |
get as close to that setting as you can, then press |
the FINE ADJ key and adjust the parameter with |
the fader in vernier mode. Press FINE ADJ again |
to leave Fine Adjust Mode. |
• You can move several faders at once. The settings |
indicated on the Scribble Strip will change for all. |
When you release the faders, the last one you |
touched will be highlighted and appear on the |
Action Display. |
For parameters assigned to the joystick:
•Press the JOYSTICK Key on the LARC2, then adjust the joystick until the Joystick Status Display shows the desired settings (Fig.
(5)Storing Your Edits
Your edits will stay in force until you change them again or load another Program or Register. To save them for
•If you've been editing a factory Program, the
960L will look for the first Register Bank with space available or the Register Bank you last stored to, and the first empty Register within that bank.
•If you’d prefer a different Register Bank, press the BANK key and enter the number of the desired bank (or scroll to it with the Navigation Arrows).
•If you'd prefer a different Register, press the REGISTER key and enter the number of the desired Register (or scroll to it with the Navigation Arrows).
•To Name a Register or Register Bank, press the NAME soft button and follow the directions below.
•To add explanatory information to a Register or Register Bank, press the INFO soft button and follow the directions below.
•When everything (target Bank, target Register, NAME and INFO) is the way you want it, press STORE again, to save.