Dolby Laboratories Digital-Satellite-Receiver manual System configuration, Copy settings

Note:

This function should not be performed if you have made changes in the menues “Basic Settings” and “LNC Configuration”, as these changes would revert to the default settings when this function is activated, and would have to be re-programm- ed.

For the new software version to be downloaded automatically, the digital receiver must be in standby mode. The downloading procedure is indicated by “SAtL” in the display. Ensure that this procedure is not interrupted by switching the receiver on or off while the download is in pro- gress.

Depending on whether you have switched the automatic soft- ware update function on or off, the receiver will check auto- matically each time it is switched on whether a new version of the operating software for your digital receiver is available. If a new version of the operating software is available, this will be indicated by a message (Fig. 8-20)displayed on screen.

To start the software update, follow the instructions displayed on your screen.

8.4.5 Copy settings

You have the facility to copy all the settings of the program- me list, antenna settings, etc. of your digital receiver from your receiver to another digital receiver of the same type, and using the same operating software version. (Fig. 8-21)

>Use a null modem cable to connect the two receivers.

>Switch on the receiver to which the settings are to be transferred.

>To copy the settings, press one of the keys on the panel of the source receiver.

The settings of this source receiver will now be trans- ferred to the other, receiving, receiver. Please note any messages displayed on screen.

8.5 System configuration

Use this menu item to view the specific data relating to your receiver.

>Use the arrow keys up/down to mark this line in the sub-menu Settings.

>Confirm by pressing OK.

>Press the Menu key to return to normal operation.

(Fig. 8-20)

(Fig. 8-21)

51